Cisco Cisco Firepower Management Center 4000

Your changes are saved. Note that your changes do not take effect until you apply the device 
configuration; see 

 for more information.

Any

You can configure the interfaces of a managed device, according to your FireSIGHT System deployment, 
from the Interfaces page of the appliance editor.

The top of the Interfaces page displays a physical hardware view of a managed Series 3 device. Series 2, 
virtual devices, Sourcefire Software for  X-Series, and ASA FirePOWER devices do not have physical 
hardware views. The following graphic shows the hardware view for a 3D8250.

The following table explains how to use the physical hardware view.

The interfaces table view, which is below the Series 3 hardware view, lists all the interfaces you have 
configured on a device. The table includes summarized information about each interface, as described 
in the following table. Note that only 8000 Series devices display the MAC Address and IP Address 
columns. See the following table for more information.

view a network module’s type, part number, and serial 
number

hover your cursor over the dark circle in 
the lower left corner of the network 
module.

select an interface in the interfaces table view

click the interface.

open an interface editor

double-click the interface.

view the name of the interface, the type of interface, 
whether the interface has link, the interface’s speed 
setting, and whether the interface is currently in bypass 
mode

hover your cursor over the interface.

view the details about an error or warning

hover your cursor over the affected port on 
the network module.