Cisco Cisco Firepower Management Center 4000

Under 

, use the Profile drop-down list to select an existing virtual router authentication 

profile or select 

. 

Click 

.

Your changes are saved. Note that your changes do not take effect until you apply the device 
configuration; see 

Control

Series 3

You can configure several advanced RIP settings pertaining to various timeout values and other features 
that affect the behavior of the protocol.

Changing any of the advanced RIP settings to incorrect values can prevent the router from 
communicating successfully with other RIP routers.

Admin/Network Admin

Select 

.

The Device Management page appears.

Next to the device where you want to edit the RIP advanced settings, click the edit icon (

).

The Interfaces tab for that device appears.

Click 

.

The Virtual Routers tab appears.

Next to the virtual router where you want to edit the RIP advanced settings, click the edit icon (

).

The Edit Virtual Router pop-up window appears.

Click 

to display the dynamic routing options.

Click 

 to display the RIP options.

In the 

 field, type a numerical value (higher is better) for the preference of the routing protocol. 

The system prefers routes learned through RIP over static routes.

In the 

 field, type the interval, in seconds, between periodic updates. A lower number determines 

faster convergence, but larger network load.

In the 

 field, type a numerical value that specifies how old routes must be, in seconds, before 

being considered unreachable.

In the 

 field, type a numerical value that specifies how old routes must be, in seconds, before 

being discarded.

In the 

 field, type a numerical value that specifies a value for infinity distance in convergence 

calculations. Larger values will make protocol convergence slower.

From the 

 drop-down list, select one of the following options to designate when requests for 

dumping routing tables should be honored: