Cisco Cisco Firepower Management Center 2000

Version 5.3.0.6

Sourcefire 3D System Release Notes

Uninstalling the Update

3. At the CLI prompt, type

expert

to access the bash shell.

4. At the bash shell prompt, type

sudo su -

5. Type the

admin

password to continue the process with root privileges.

6. At the prompt, enter the following on a single line:

install_update.pl /var/sf/updates/Sourcefire_3D_

Device_Virtual64_VMware_Patch_Uninstaller-5.3.0.6-11.sh

The uninstallation process begins.

WARNING!

If you encounter issues with the uninstallation, do not restart

the uninstallation. Instead, contact Support.

7. After the uninstallation finishes, log into the managing Defense Center and

select Devices > Device Management. Confirm that the device where you

uninstalled the update has the correct software version: Version 5.3.0.5.

8. Verify that the appliances in your deployment are successfully communicating

and that there are no issues reported by the health monitor.

Uninstalling the Update from Sourcefire Software for X-Series

The following procedure explains how to uninstall the Version 5.3.0.6 update from

Sourcefire Software for X-Series. You cannot use a Defense Center to uninstall

the update. You must complete the following procedure from each VAP group

individually in order to fully uninstall the update from Sourcefire Software for

X-Series.
Uninstalling the Version 5.3.0.6 update results in the Sourcefire Software for

X-Series running Version 5.3.

To uninstall the update:

1. Read and understand

2. Log into a VAP where you want to uninstall the update.

For example, to log into the first VAP in the intrusion VAP group:

CBS# unix su

[root@machine admin]# rsh intrusion_1

3. At the prompt, run the following command to configure your session

environment to run Sourcefire scripts:

source /opt/sf/profile