Cisco Cisco OptoStar II Platform Installationsanleitung
Operating using ICIM LCD, Continued
Sub-Menu 1 -- Optical Information
The illustration below shows sub-menu 1 of the OptoStar II forward receiver
module - Optical Information.
module - Optical Information.
The default lower limit of the optical input power alarm threshold is -4. 0 dBm;
and upper limit is 4.0 dBm. The cursor stays in the “Low” box by default. Also,
this sub-menu provides specific value of optical input power.
and upper limit is 4.0 dBm. The cursor stays in the “Low” box by default. Also,
this sub-menu provides specific value of optical input power.
•
To configure the lower limit of the optical alarm threshold (minimum output
power is no less than (standard value - 4. 0) dBm).
power is no less than (standard value - 4. 0) dBm).
1. Press SET button to start the configuration;
2. Press ▲▼ buttons to change the value, and press SET button to confirm;
3. Press ► button to move the cursor to “Set”;
4. Press SET button to save the configuration.
2. Press ▲▼ buttons to change the value, and press SET button to confirm;
3. Press ► button to move the cursor to “Set”;
4. Press SET button to save the configuration.
•
To configure the upper limit of the optical alarm threshold (maximum output
power is no more than (standard value + 4. 0) dBm).
power is no more than (standard value + 4. 0) dBm).
1. Press ▼ button to leave the cursor in the “High” box;
2. Press SET button to start the configuration;
3. Press ▲▼ buttons to change the value, and press SET button to confirm;
4. Press ► button to move the cursor to “Set”;
5. Press SET button to save the configuration.
2. Press SET button to start the configuration;
3. Press ▲▼ buttons to change the value, and press SET button to confirm;
4. Press ► button to move the cursor to “Set”;
5. Press SET button to save the configuration.
Continued on next page
OL-29662-03
Operation
3-7