Cisco Cisco 1000BASE-T SFP Fehlerbehebungsanleitung
connectors can be active for a port and the active connector is determined by the interface configuration
command media-type {rj45 | sfp}.
command media-type {rj45 | sfp}.
In a WS-X4948 chassis, the last four ports (ports 45 to 48) are dual-mode capable.
Switch(config)#interface gigabitethernet 5/5
Switch(config-if)#media-type rj45
Switch(config-if)#media-type rj45
Enter the show interface capabilities command in order to provide the Multiple Media Types field, which
displays the value no if a port is not dual-mode capable and lists the media types (sfp and rj45) for dual-
mode capable ports.
displays the value no if a port is not dual-mode capable and lists the media types (sfp and rj45) for dual-
mode capable ports.
SFP Interfaces of X2/Twin Gigabit Converter Do Not Come Up
The default configuration mode is X2, so, if you plan to deploy 10-Gigabit interfaces, you do not need to
configure anything. If you want to deploy Gigabit interfaces, that is, TwinGig Convertors, you must
configure the associated port-group.
configure anything. If you want to deploy Gigabit interfaces, that is, TwinGig Convertors, you must
configure the associated port-group.
First gather the information on how the X2 slots on a module are grouped. Then, to configure the modes of
operation for each X2 port group in which you want to deploy Gigabit, enter the hw-module module m
port-group p select gigabitethernet
operation for each X2 port group in which you want to deploy Gigabit, enter the hw-module module m
port-group p select gigabitethernet
command. This configuration is preserved across power cycles and
reloads.
Refer to
Selecting X2/TwinGig Convertor Mode
for more information.
The Links Do Not Come Up in Cisco 3800 Series Routers with SPFs for Connecting to Cisco
Catalyst Switches
Catalyst Switches
When the SFPs are used to connect a Cisco 3800 Series router to a Cisco Catalyst switch, the link cannot
come up, and the show interface command shows down/down.
come up, and the show interface command shows down/down.
In order to overcome this issue, enable autonegotiation on both the router and switch. In order to
permanently resolve the issue, upgrade the Cisco IOS software of the router to release 12.4(8) or later,
which can be downloaded from
permanently resolve the issue, upgrade the Cisco IOS software of the router to release 12.4(8) or later,
which can be downloaded from
Cisco Downloads
(
registered
customers only) . This issue is documented
at Cisco bug
CSCsc04961
(
registered
customers only) .
Cisco Support Community - Featured Conversations
Cisco Support Community
is a forum for you to ask and answer questions, share suggestions, and
collaborate with your peers. Below are just some of the most recent and relevant conversations happening
right now.
right now.
3548-XL-EN to switch with small...
5 years, 3 months ago
Optical transceiver
1 year, 10 months ago
GLC-LH-SM transceiver modules
9 months, 3 weeks ago
12-24 port small form factor...
3 months, 1 week ago
cisco 2970
4 years, 6 months ago
GBICs and SFP modules
6 years, 10 months ago
Want to see more? Join us by clicking here
david-flores
1 Reply
lubosbella
1 Reply
shiva.shivakumar
3 Replies
patrick.beaven
4 Replies
carl_townshend
2 Replies
ovt_at_redcenter.ru
1 Reply