Cisco Cisco Packet Data Gateway (PDG)
C H A P T E R
3
HNB-GW Service Configuration Procedures
This chapter is meant to be used in conjunction with the other chapters that describes the information needed
to configure the system to support HNB-GW functionality for use in HNB access networks.
to configure the system to support HNB-GW functionality for use in HNB access networks.
It is recommended that you identify the options from the previous chapters that are required for your specific
deployment. You can then use the procedures in this chapter to configure those options.
deployment. You can then use the procedures in this chapter to configure those options.
This chapter describes following:
•
•
RTP Pool Configuration, on page 90
•
HNB-GW Service Configuration, on page 99
•
DSCP Marking Configuration, on page 105
•
DHCP Configuration, on page 106
•
IuCS over ATM Configuration, on page 108
•
Iu-Flex Configuration, on page 110
•
Logging Facility Configuration, on page 112
•
Congestion Control Configuration, on page 113
•
Alarm and Alert Trap Configuration, on page 114
•
SNMP-MIB Traps for HNB-GW Service, on page 114
•
Event IDs for HNB-GW Service, on page 115
At least one packet card must be made active prior to service configuration. Information and instructions
for configuring the packet cards to be active can be found in the Configuring System Settings chapter of
the System Administration Guide.
for configuring the packet cards to be active can be found in the Configuring System Settings chapter of
the System Administration Guide.
Important
HNB-GW Administration Guide, StarOS Release 19
81