Cisco Cisco Email Security Appliance X1050 Betriebsanweisung

Note that this example shows using the demonstration certificate that is pre-installed on the appliance. 
You may enable HTTPS services with the demonstration certificate for testing purposes, but it is not 
secure and is not recommended for general use.

You can enable HTTPS services using the System Setup Wizard in the GUI. Refer to “Define the Default 
Router (Gateway), Configure the DNS Settings, and Enabling Secure Web Access” in the “Setup and 
Installation” chapter of the Cisco IronPort AsyncOS for Email Configuration Guide. 

After the changes from this command are committed, users can access the Graphical User Interface 
(GUI) using the URL for secure HTTPS: 

https://192.168.2.1

mail3.example.com> interfaceconfig

Currently configured interfaces:

1. Management (192.168.42.42/24: mail3.example.com)

2. PrivateNet (192.168.1.1/24: mail3.example.com)

3. PublicNet (192.168.2.1/24: mail3.example.com)

Choose the operation you want to perform:

- NEW - Create a new interface.

- EDIT - Modify an interface.

- GROUPS - Define interface groups.

- DELETE - Remove an interface.

[]> edit

Enter the number of the interface you wish to edit.

[]> 3

IP interface name (Ex: "InternalNet"):

[PublicNet]>

Would you like to configure an IPv4 address for this interface (y/n)? [Y]> y