Manualsbrain.com
  1. Handbücher
  2. Marken
  3. Cisco
  4. Cisco Firepower Management Center 2000

Cisco Cisco Firepower Management Center 2000

Download
Seite von 1844
 
51-12
FireSIGHT System User Guide
 
Chapter 51      Configuring Appliance Settings 
  Setting the Time Manually
Caution
Do not shut off appliances using the power button; it may cause a loss of data. Shut down appliances 
completely via the Appliance Process page.
To shut down or restart your appliance:
Access: 
Admin
Step 1
Select 
System > Local > Configuration
.
The Information page appears.
Step 2
Click 
Process
.
The Appliance Process page appears.
Step 3
Specify the command you want to perform:
On Defense Centers:
  •
To shut down the appliance, click 
Run Command
 next to 
Shutdown 
Defense Center.
  •
To reboot the appliance, click 
Run Command
 next to 
Reboot 
Defense Center. Note that this logs you 
out of the Defense Center.
  •
To restart the appliance, click 
Run Command
 next to 
Restart 
Defense Center
 Console
. Note that 
restarting the Defense Center may cause deleted hosts to reappear in the network map.
On managed devices:
  •
To shut down the appliance, click 
Run Command
 next to 
Shutdown Appliance
.
  •
To reboot the appliance, click 
Run Command
 next to 
Reboot Appliance
. Note that this logs you out of 
the device.
  •
To restart the appliance, click 
Run Command
 next to 
Restart Appliance Console
.
  •
To restart the Snort process, click 
Run Command
 next to 
Restart Snort
.
Setting the Time Manually
License: 
Any
If the Time Synchronization setting in the currently applied system policy is set to 
Manually in Local 
Configuration
, then you can manually set the time for the appliance using the Time page in the local 
configuration. 
You must use native applications, such as command line interfaces or the operating system interface, to 
manage time settings for Sourcefire Software for  X-Series. For more information, see the Sourcefire 
Software for  X-Series Installation Guide.
If the appliance is synchronizing its time based on NTP, you cannot change the time manually. Instead, 
the NTP Status section on the Time page provides the following information: