Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
System Element Configuration Procedures
▀ Creating Contexts
▄ Cisco ASR 5000 Series System Administration Guide
OL-22970-01
Creating Contexts
Even though multiple contexts can be configured to perform specific functions, they are all created using the same
procedure.
procedure.
I
MPORTANT
:
Commands used in the configuration examples in this section provide base functionality to the
extent that the most common or likely commands and/or keyword options are presented. In many cases, other optional
commands and/or keyword options are available. Refer to the Command Line Interface Reference for complete
information regarding all commands.
commands and/or keyword options are available. Refer to the Command Line Interface Reference for complete
information regarding all commands.
To create a context, apply the following example configuration:
Notes:
Repeat to configure additional contexts.
I
MPORTANT
:
We recommend that if your system is using Ethernet 10/100 Line Cards, at least
one context be configured per physical port in order to ensure adequate bandwidth for subscriber
sessions.
sessions.
Viewing and Verifying Contexts
Step 1
Verify that your contexts were successfully created by entering the following command:
The output is a two-column table that looks similar to the example below. In this example, it shows that two contexts
were created: one called source and one called destination.
were created: one called source and one called destination.