Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Troubleshooting the System
▀ Detecting Faulty Hardware Using Component LEDs
▄ Cisco ASR 5000 Series System Administration Guide
OL-22970-01
Color
Description
Troubleshooting
Blinking
Green
Green
Tasks or processes being migrated
from the active SMC to the
redundant/secondary SMC
from the active SMC to the
redundant/secondary SMC
Verify that the Active LED on the redundant PSC is also blinking green.
If so, there is an issue with the active PSC and the system is transferring its
processes. Refer to one or more of the following to help analyze this
problem:
If so, there is an issue with the active PSC and the system is transferring its
processes. Refer to one or more of the following to help analyze this
problem:
The Monitoring Hardware Status chapter in this reference for show
commands; the outputs of which will assist in further determining
the problem.
commands; the outputs of which will assist in further determining
the problem.
The Configuring and Viewing System Logs chapter in this reference
for information on configuring specific types of logging
information and how to view logs.
for information on configuring specific types of logging
information and how to view logs.
SNMP MIB Reference for information on associated status and
alarm conditions.
alarm conditions.
None
Card is not receiving powerORCard
in Active Mode
in Active Mode
Verify that the RUN/FAIL LED is green. If so, the card is receiving
power and POST test results are positive. If it is off, please refer to
the PSC RUN/FAIL LED States section of this chapter for
information on troubleshooting.
power and POST test results are positive. If it is off, please refer to
the PSC RUN/FAIL LED States section of this chapter for
information on troubleshooting.
Check the state of the Active LED. If it is green, the card is in
active mode. If needed, refer to the Manually Initiating a PSC
Migration section in this chapter for information on configuring the
card to serve as a redundant component.
active mode. If needed, refer to the Manually Initiating a PSC
Migration section in this chapter for information on configuring the
card to serve as a redundant component.
Checking the LEDs on the SPIO(s)
Each SPIO is equipped with status LEDs as listed below:
RUN/FAIL
Active
Standby
In addition to the LEDs listed above, each interface to the management network (both RJ-45 and SFP) are equipped
with the following LEDs:
with the following LEDs:
Link
Activity