Cisco Cisco Packet Data Gateway (PDG) Fehlerbehebungsanleitung
Configuring System Settings
Configuring Packet Processing and Line Card Availability ▀
Cisco ASR 5000 Series System Administration Guide ▄
OL-22970-01
The
specifies the order in which the system will use standby PSCs as redundant
components.
By default, the system uses the standby PSC or PSC2 in the highest-numbered slot (slot 16) as the first
card to use for redundancy. This step is required if there are processing cards installed in the system
that are in standby mode, and you want to configure the system to use an order other than the default.
that are in standby mode, and you want to configure the system to use an order other than the default.
is the chassis slot number of the standby PSC/PSC2 that you want to use first as a
redundant component.
is the chassis slot number of the standby processing card that you
want to use second as a redundant component.
is the chassis slot number of the standby
PSC that you want to use as the last redundant component.
Example
A system has three PSCs or PSC2s that are in standby mode. They are installed in chassis slots 14, 15, and 16. If an
active processing card fails, and you want the PSC in slot 15 to replace the failed PSC followed by the PSC in slot 14,
enter the following command:
A system has three PSCs or PSC2s that are in standby mode. They are installed in chassis slots 14, 15, and 16. If an
active processing card fails, and you want the PSC in slot 15 to replace the failed PSC followed by the PSC in slot 14,
enter the following command:
In the unlikely event that the PSCs in chassis slots 15 and 14 are unavailable, the system automatically uses the
remaining standby PSC in slot 16 for redundancy.
Save the configuration as described in the Verifying and Saving Your Configuration chapter.
remaining standby PSC in slot 16 for redundancy.
Save the configuration as described in the Verifying and Saving Your Configuration chapter.
Verifying Packet Processing and Line Card Configurations
Verify that the configuration was successful. Depending on the type of card(s) you activated, enter either or both of the
following commands:
following commands:
Any card that you made active should now have an operational status of Active.