Brother RJ-3150 Verweisanleitung
Raster Command Reference
- 5 -
4. Print Data
4. Print Data
4.1 Print data overview
The print data is constructed of the following: (1) initialization commands, (2) control codes, (3) raster data,
and (4) print commands. If the print job consists of multiple pages, (2) through (4) are repeated.
(1) Initialization commands
Specified only once at the beginning of the job.
Sequence
Command Name
Description/Example
1
Invalidate
Sends a 350-byte invalidate command with the RJ-3050/3150 or a
200-byte invalidate command with the RJ-2030/2050/2140/2150,
and then resets the printer to the receiving state.
200-byte invalidate command with the RJ-2030/2050/2140/2150,
and then resets the printer to the receiving state.
2
Initialize
Initializes for printing.
1Bh, 40h (Fixed)
1Bh, 40h (Fixed)
(2) Control codes
Added at the beginning of each page and sent for each page.
Sequence
Command Name
Description/Example
1
Switch dynamic
command mode
command mode
Switches the command mode of the printer to raster mode.
1Bh, 69h, 61h, 01h
1Bh, 69h, 61h, 01h
2
Additional media
information
command
information
command
1Bh, 69h, 55h, 77h, 01h, 127 bytes of media information
Note
If the media information is the same as when printing was
last performed, it is unnecessary to send the additional
media information command.
Note
If the media information is the same as when printing was
last performed, it is unnecessary to send the additional
media information command.
3
Print information
command
command
Sets the print information for the printer.
For a length setting of 100 mm for 80-mm-wide continuous length
tape:
1Bh, 69h, 7Ah, 00h, 0Ah, 50h, 64h, F0h, 02h, 00h, 00h, 00h, 00h
For a length setting of 100 mm for 80-mm-wide continuous length
tape:
1Bh, 69h, 7Ah, 00h, 0Ah, 50h, 64h, F0h, 02h, 00h, 00h, 00h, 00h
4
Specify margin
amount
amount
Specifies the amount of the margins.
For 3 mm margins:
1Bh, 69h, 64h, 18h, 00h
For 3 mm margins:
1Bh, 69h, 64h, 18h, 00h
5
Select compression
mode
mode
Selects the compression mode for raster graphics.
To send the data compressed to TIFF format:
4Dh, 02h
To send the data compressed to TIFF format:
4Dh, 02h