Samsung SCC-C7435P Benutzerhandbuch

❚

• Do not disassemble the camera on your own.

•  Always be careful when handling the camera. Do not strike the camera by your fists or shake 

it. Please be careful not to be careless when storing and operating it.

• Do not place or operate the camera in any wet environment such as rain or wet surfaces.

•  Do not clean the camera with rough sandpaper. Please always use a dry cloth when cleaning it.

•  Put the camera in a cool area free from direct sunlight. Otherwise, the camera may be damaged.

•  Power adaptor: 24V AC, 3.0A

•  If the camera is installed or rebooted after a power failure under 0 ºC temperature condition, frost 

may appear on the DOME cover. Also, PTZ initial error and bad image quality may be displayed 

under -10 ºC.

•  After the problems, the recovery will be performed as following:  

(Conditions: No wind and under -45 ºC temperature which is guaranteed the normal operation)

1 It is possible to defrost the DOME cover within 3 hours after the power on.

2  For PTZ initial error, reboot will be executed every 10 minutes and the camera will work normally 

within 3 hours after the power on. 

※

If PTZ error occurs after the initial boot, the message shown below will be displayed.  

     "WARMING UP NOW...", "PLEASE WAIT 10 MINUTES."

3 For bad image quality, the camera will work normally within 3 hours after the power on.

❚

For the Address Setup of Smartdome, use “SW902”, “SW903”, and “SW904”. 

You can set the address from 0 to 255. Set up the address digit for 100 with “SW902”, for 10 

with “SW903”, for 1 with “SW904”.

For example, if the camera address is “1”, you can setup as follows.

Installation

SW902

SW903

SW904

SCC-C7435-EU.indb   9

2008-09-12   오전 10:36:58