Samsung NV70J7554KS Benutzerhandbuch
English - 11
nstallation in the cabinet
With built-in furniture, plastic surfaces and adhesive for the oven should be resistant to 90 °C inside of
the furniture and to 75 °C for adjacent furniture. Samsung will take no responsibility for damage of plastic
surfaces or adhesive from the heat.
There should be a ventilation gap in the base of the kitchen cabinet where the oven is to be placed.
There should be a ventilation gap in the base of the kitchen cabinet where the oven is to be placed.
For ventilation, a gap of about 50 mm should be left between the lower shelf and the supporting wall.
If the oven is to be installed below a hob, the hob’s installation instructions should be followed.
595
370
560
545
21
595
Max.50
Min.550
Min.560
Min.50
Min.590 ~ Max.600
Min.460 x Min.50
Built-in
572 550
595
370
560
545
21
85
595
175
Max.
494
Min.550
Min.560
Min.600
Min.460 x Min.50
Built-under
Built-in + Built-under
572 550
Max. 506
Push the appliance completely into the cabinet and fix the oven firmly on both sides using 2 screws.
Make sure that a gap of at least 5 mm should be left between the appliance and the adjacent cabinet.
After installation, remove the vinyl protective film, tape, paper and accessories from the door and inside
After installation, remove the vinyl protective film, tape, paper and accessories from the door and inside
of oven. Before uninstalling the oven from the furniture, disconnect the oven from the power supply and
release the 2 screws on the both sides of the oven.
WARNING: The built-in furniture must have a minimum ventilation gap for Air-flow as shown
on picture. Do not cover this hole with strips of wood, for this is used to provide ventilation.
The front exterior of the oven such as handle is different model by model. But the size of the
The front exterior of the oven such as handle is different model by model. But the size of the
oven in the picture is same.
02
INS
TALLA
TALLA
TION
NV70J7554KS_ML_DG68-00607B-00_EN.indd 11
2015-11-04 11:06:01