Samsung SNC-L200N Benutzerhandbuch

IP router is needed if you want to use the Internet besides Netcam. You must
configure IP router once so that Netcam can operate properly.
Whether you have an existing IP router or purchased a new one, you must configure
Port Forwarding so that Netcam can operate properly.
Please refer to IP Router User’s Manual.

*  IP Address and Port set in the IP router will be needed later when you configure

Netcam. Please do not forget them. 

*  If you remember the Subnet Mask, Gateway in the IP router connection status

confirmation page, it would be helpful later when you install Netcam.

* Port 

Forwarding

If you want to use Netcam via IP router, you need to allocate a unique port number
to Netcam.
Numbers from 1 through 65535 can be used as port numbers.
However, do not used the following port numbers.

FTP: 21
Telnet: 23
SMTP: 25
DNS: 53
POP3: 110
HTTPS: 443
ICQ: 4000
IRC: 6661~6667

To prevent the conflict between the port and other programs from happening, it’s
better to set the port number greater than 10,000.

You need to install the SNC Installer program from the installation CD shipped with
the product.
SNC Installer searches Netcam on the local network, shows the unique MAC
Address, and configures Netcam.

1. Insert the provided CD to the CD-ROM drive.

2. Double click and run “SNC Installer.exe” from the CD-ROM.

3. Click “Next.”

4. Install starts.