Canon ir2016, ir2020 Handbuch

3-4

1) Open the front cover of the host machine.

2) Remove the four RS tightening screws (M3 x 8) [1], and then detach the

rear cover [2].

F-3-19

1) Remove all connectors from the finisher controller PCB [1], and then open

the two wire saddles [2].

2) Open ten wire saddles[3] and then remove the harnes.

F-3-20

3) Remove two wire saddles[4] behind the finisher controller, and then re-

move the harnes[5].

F-3-21

4) Remove the two RS tightening screws (M3 x 8) [1], and then remove the

finisher controller PCB [2] together with the mount.

F-3-22

5) Remove the timing belt [1].

F-3-23

1) Remove the stepped screw [1] (front side) and RS tightening screw (M3

x 8) [2], and then remove the inlet guide [3].

F-3-24

1) Remove the RS tightening screw (M3 x 8) [1]. Remove the two reusable

bands [2] using pliers or the like, and then remove the harness from the edge

saddle [3].

2) Remove the harness [5] from the guide [4], and then remove the front cov-

er safety switch [6].

F-3-25

1) Remove the three TP screws (M4 x 12) [1], one RS tightening screw (M3

x 8) [2], and the drive unit [3].

[1]

[2]

[1]

[2]

[3]

[3]

[3]

[5]

[4]

[1]

[2]

[1]

[1]

[3]

[2]

[5]

[2]

[6]

[4]

[3] [1]