Canon ir2016, ir2020 Handbuch
Chapter 3
3-16
F-3-96
3.5.6.2 Removing the Inlet Sensor
0010-6679
1) Remove the P tightening screws (M4x10) [1], and then detach the sensor
cover [2].
F-3-97
2) Disconnect the connector [3], and then remove the inlet sensor [4].
F-3-98
3.5.7 Stack Slide HP Sensor
3.5.7.1 Removing the Top Cover
0010-6682
1) Remove the three RS tightening screws (M3 x 8) [1], and then detach the
top cover [2].
F-3-99
3.5.7.2 Removing the Inner Cover of the Finisher
0010-6683
1) Open the front cover of the host machine.
2) Remove the four RS tightening screws (M3 x 8) [1], and then detach the
rear cover [2].
F-3-100
3.5.7.3 Removing the Finisher Controller PCB
0010-6685
1) Remove all connectors from the finisher controller PCB [1], and then open
the two wire saddles [2].
2) Open ten wire saddles[3] and then remove the harnes.
F-3-101
3) Remove two wire saddles[4] behind the finisher controller, and then re-
move the harnes[5].
[1]
[2]
[1]
[2]
[4]
[3]
[1]
[2]
[1]
[2]
[1]
[2]
[3]
[3]
[3]