Acer altos s300
3 Cabling and configuration
32
Delayed Start
If you select this option, the disk drives will spin up sequentially i.e. not
all together. To enable this feature, install a jumper at location JP11
on the ESM and CSM (whichever is installed). If two CSMs are installed,
the jumper should be installed on both CSMs.
all together. To enable this feature, install a jumper at location JP11
on the ESM and CSM (whichever is installed). If two CSMs are installed,
the jumper should be installed on both CSMs.
Powering on an AC enclosure
1.
Ensure all cables have been attached as described in the preceding
sections.
sections.
2.
Attach the AC power cords to the power supplies and turn the
power supply switches to the On (-) position (see figure below).
power supply switches to the On (-) position (see figure below).
3.
Power on the host system and the Altos S300 series enclosure will
power on also.
power on also.
Note: Powering off all the attached host systems will power off
the Altos S300 series enclosure also. Refer to “Power up” on page
31 (jumper JP13).
the Altos S300 series enclosure also. Refer to “Power up” on page
31 (jumper JP13).
Warning! This equipment must be connected to an earthed
mains socket outlet. Ensure the power cabling provides
earthing continuity to the equipment.
mains socket outlet. Ensure the power cabling provides
earthing continuity to the equipment.
1
2
1
2
0
I
0
I
Insert Power cords into
power connectors
Mute