Acronis true image 9.1 Handbuch

 

Acronis True Image Workstation uses the following ports and IP addresses for remote 
operation: 
•  server (Acronis True Image Agent) UDP port: 9876 
•  server (Acronis True Image Agent) TCP port: 9876, if busy chose port at 

•  client (Acronis True Image Management Console) UDP port: 9877, if busy 

•  IPv4 multicast address: 239.255.219.45 
•  IPv6 multicast address: FF05::fAA5:741E. 
You might have to set the appropriate firewall access options. Options for the Windows 
Firewall, included in Windows XP Service Pack 2 and Windows 2003 Server, are set 
automatically during Acronis True Image Workstation components installation. However, 
make sure that the option File and Printer Sharing in the Control panel -> Windows 
Firewall -> Exceptions is enabled on the remote computer, before the remote operation 
starts. 

You can run Acronis True Image Workstation in Windows by selecting Start -> Programs -
> Acronis -> Acronis True Image Workstation -> Acronis True Image Workstation 
or clicking on the appropriate shortcut on the desktop. 
If your operating system does not load for some reason, you can run Acronis Startup 
Recovery Manager. However, this must be activated prior to use; see 

3.4  Acronis Startup 

 to learn more about this procedure. To run the program, press F11 during 

workstation bootup, when you see a corresponding message that tells you to press that key. 
Acronis True Image Workstation will be run in the standalone mode, allowing you to recover 
the damaged partitions. 
If your disk data is totally corrupted and you cannot boot (or if you have not activated 
Acronis Startup Recovery Manager), load the standalone Acronis True Image Workstation 
version from the bootable media (supplied with the retail box or created by you using 
Rescue Media Builder) or RIS-server. Then you will be able to restore the disk from its 
previously created image. 

To run Acronis True Image Management Console, select Start -> Programs -> Acronis -
> Acronis True Image Management Console -> Acronis True Image Management 
Console. 

You can remove any Acronis True Image Workstation component separately by selecting 
Control panel -> Add or remove programs -> <The component name> -> 
Remove. Then follow instructions on the screen. You may have to reboot your computer 
afterwards to complete the task. 
 

14                                                                                      Copyright © Acronis, Inc., 2000-2006