acousti case c6606a beige super midi tower with apd, no psu Benutzerhandbuch

Pack Contents: 
The AcoustiCase™ AC C6606 pack contains 
15 pieces, of 3 different materials. 

ONLY position the materials as directed in the fitting directions and as depicted in the graphics above.
DO NOT cover the ventilation holes at the rear of the case with any materials.
DO NOT position the rear of the case close to a permanent heat source, such as a radiator, or very close to an airflow obstruction, 
such as a wall. This may inhibit air circulation required for cooling. Leave a gap at the rear of the case of at least 20cm to allow 
free movement of air in and out of the case.
DO NOT position materials inside the case in such a way that may inhibit the correct functioning of any internal components, 
especially cooling fans, disc drives and moving parts. These components require adequate space and ventilation. Whilst every care 
has been taken to produce a set of templates that will be appropriate for the majority of component configurations, it is the 
responsibility of the machine builder to position the materials appropriately to facilitate normal functioning of internal components.

Fitting Directions:  
Fit according to the positions indicated, in the numerical order shown 
from    to    . Where self adhesive is on the reverse of the materials, 
remove the backing paper and adhere lightly to clean and dust-free 
surfaces, making sure that the material is correctly positioned. If you 
make a mistake - it can be re-applied for a second attempt - but be 
aware that excessive re-application will cause a deterioration in the 
adhesive. Once well positioned, press the materials firmly into place.

Ensure you read the important safety information before 
installing the materials.  

V 1.2

20mm

20mm

Optional

         The system speaker and 
accompanying 80mm internal fan 
bracket is an optional component.  

The detachable portions indicated on 
items      and     can be removed if an 
internal fan is installed.