Alcatel-Lucent omniaccess 4308 Benutzerhandbuch

Part 031638-00

May 2005

Serial Console port

This port is for connecting a local management console. It is required to access 
the text-based Command-Line Interface (CLI) for initial configuration of the 
Alcatel Wireless LAN Switch. The CLI can also be used for switch management 
and troubleshooting.

The port accepts an RS-232 serial cable, an RJ-45 male connector. See 

 for more port and cable specifications.

See the Alcatel AOS-W User’s Guide for information on using the features 
available through this port.

Fans/heat exhaust (on side)

Three independent fans promote proper air circulation for cooling the Alcatel 
Wireless LAN Switch.

During operation, the air vents on the left and right sides of the chassis must 
remain unobstructed by cables or mounting equipment. For proper air 
circulation, leave at least 10 cm (4 inches) of clearance on the left and right of 
the chassis.

Holes for attaching rack mounting brackets (on side)

Power Input Socket (on back)

The power input socket on the back of the switch accepts a power cord with a 
standard IEC320 connector. For proper safety and performance, the power 
cord must be rated to 10 A and conform to grounded electrical standards in the 
country where the product is operated.

The Alcatel OmniAccess 4304 is identical to the Alcatel OmniAccess 4308 
except that it is licensed to support four Access Points only. All other features 
and functions are the same as the Alcatel OmniAccess 4308.

The Alcatel OmniAccess 4304 software license can be upgraded to an Alcatel 
OmniAccess 4308 and able to support up to 16 Access Points. For information 
on upgrading the Alcatel OmniAccess 4304 to an Alcatel OmniAccess 4304, 
contact your Alcatel sales representative to visit the support website.