Aopen n250al Benutzerhandbuch
10/100/1000Mbps LAN Supported
On the strength of Gigabit LAN controller on board (for n250a-FR and n250a-L),
this motherboard provides 10/100/1000Mbps Ethernet for office and home use
(for n250a, it is 10/100 Mbps). The Ethernet RJ45 connector is located on the top
of USB connectors. The right hand side LED indicates link mode; it lights in orange
when linking to network. The left hand side LED indicates the transfer mode and
will light in green when data is transferring at 100Mbps (never lights while at
10Mbps), but will light in orange when transferring in Gigabit’s mode. To enable or
disable this function, you may simply adjust it through BIOS. To enable LAN
wakeup function, you have to set the “Wake on PCI Card” enable in the BIOS
“Power Management Setup” section.
this motherboard provides 10/100/1000Mbps Ethernet for office and home use
(for n250a, it is 10/100 Mbps). The Ethernet RJ45 connector is located on the top
of USB connectors. The right hand side LED indicates link mode; it lights in orange
when linking to network. The left hand side LED indicates the transfer mode and
will light in green when data is transferring at 100Mbps (never lights while at
10Mbps), but will light in orange when transferring in Gigabit’s mode. To enable or
disable this function, you may simply adjust it through BIOS. To enable LAN
wakeup function, you have to set the “Wake on PCI Card” enable in the BIOS
“Power Management Setup” section.
Speed LED (Left)
Green 100Mbps
Orange Gigabit mode
ACT LED (Right)
Orange
21