ASUS mypal a600 Benutzerhandbuch
Avolites Pearl 2000 Operators Manual - page
32
P2000MAN.DOC 19/10/99 17:59
3.7.2 Adjusting the Speed and Crossfade of your Chase
Connect the Chase. You can now control the Speed and Crossfade times
of your Chase using the two Wheels.
of your Chase using the two Wheels.
3.7.3 Stopping and Starting your Chase
The STOP and GO buttons stop and start a Connected Chase.
The STOP button steps through a Stopped Chase.
⇒
Note that when stepping through a Chase in this fashion, the steps will
be executed without any timing information that may be programmed in
them.
them.
3.7.4 Changing the direction of a Chase
You can change the direction of a Connected Chase by using the three
Arrow Keys at the bottom of the Sequence Control area. The Right and
Left Arrows send the Chase Forwards and Backwards respectively, and
the Double-Ended Arrow makes the Chase Bounce backwards and
forwards, with the Right or Left Arrow indicating which direction it is currently
going in.
Arrow Keys at the bottom of the Sequence Control area. The Right and
Left Arrows send the Chase Forwards and Backwards respectively, and
the Double-Ended Arrow makes the Chase Bounce backwards and
forwards, with the Right or Left Arrow indicating which direction it is currently
going in.
A number of the Chase Parameters are definable for each chase. Details of
these can be found in section 7.27 Setting the Chase Parameters. Chases
are discussed in more detail in Chapter 7 Programming Chases.
these can be found in section 7.27 Setting the Chase Parameters. Chases
are discussed in more detail in Chapter 7 Programming Chases.