ASUS polo Benutzerhandbuch

ASUS POLO User’s Manual

3. HARDWARE SETUP

Connectors

3. H/W SETUP

3.8.2

Internal Connectors

2) Floppy Disk Drive Connector (34-1 pin FLOPPY)

This connector supports the provided floppy drive ribbon cable. After connecting
the single end to the board, connect the two plugs on the other end to the floppy
drives. (Pin 5 is removed to prevent inserting in the wrong orientation when
using ribbon cables with pin 5 plugged).

NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.

POLO Floppy Disk Drive Connector

PIN 1

POLO

1) Wake-On-LAN Connector (3-pin WOL_CON)

This connector connects to a LAN card with a Wake-On-LAN output, such as
the ASUS PCI-L101 Ethernet card (see 7. Appendix). The connector powers up
the system when a wakeup packet or signal is received through the LAN card.

IMPORTANT: To use this feature, enable the Wake-On-LAN feature in BIOS
(see 4.5.1 Power Up Control) and make sure that system has an ATX power
supply with at least 720mA +5V standby power.

POLO Wake-On-LAN Connector

IMPORTANT: Requires an ATX power
supply with at least 720mA +5 volt
standby power

+5 Volt Standby PME

Ground

WOL_CON

POLO