3com 3c905c-tx-m, 3c905c-tx Benutzerhandbuch
42
C
HAPTER
4: N
ET
W
ARE
C
LIENT
AND
S
ERVER
D
RIVER
I
NSTALLATION
3 Add the following two lines to the AUTOEXEC.NCF file:
load C:\NWSERVER\3C90X.LAN slot=<slot>
NAME=<name> FRAME=<frametype>
bind ipx to <name> net=<number>
4 Save and exit the file, and then reboot the server.
NetWare 4.10 and 4.11
To install the driver in a NetWare 4.10 or 4.11 server:
1 Install the NetWare server software.
The NIC Selection menu appears.
2 Press Enter to display a list of NIC drivers.
3 Press Insert to install an unlisted driver.
4 Insert EtherDisk diskette 3 in your PC, and then
press Enter.
5 Press Enter after the driver is loaded.
6 Save parameters and continue the installation.
Multiple NICs
To support more than one NIC in a NetWare server, change
the AUTOEXEC.NCF file to the following format:
the AUTOEXEC.NCF file to the following format:
load C:\NWSERVER\3C90X.LAN slot=<slot1>
NAME=<name1> FRAME=<frametype1>
bind ipx to <name1> net=<net1>
load C:\NWSERVER\3C90X.LAN slot=<slot2>
NAME=<name2> FRAME=<frametype2>
bind ipx to <name2> net=<net2>
The values <slot1> and <slot2> are the numbers of
the PCI slots in which the NICs are physically installed.
To view the numbers of these PCI slots, use the
3Com Configuration and Diagnostic program for DOS.
See the next section, “Verifying the PCI Slot Number,”
for instructions.
the PCI slots in which the NICs are physically installed.
To view the numbers of these PCI slots, use the
3Com Configuration and Diagnostic program for DOS.
See the next section, “Verifying the PCI Slot Number,”
for instructions.
book Page 42 Monday, March 15, 1999 1:31 PM