3com WX4400 3CRWX440095A Benutzerhandbuch
Create Your MAPs
101
5 In the Fingerprint box, type the 16-digit hexadecimal number of the
MAP’s encryption fingerprint. Use either of the following formats:
11:22:33:44:55:66:77:88:99:aa:bb:cc:dd:ee:ff:00
1122:3344:5566:7788:99aa:bbcc:ddee:ff00
A MAP’s fingerprint is the hash value of the MAP’s public encryption key.
The fingerprint is displayed on a label on the back of the MAP, and is
labeled RSA key. If the MAP is already installed and operating, use the CLI
command display dap status command to display the fingerprint.
The fingerprint is displayed on a label on the back of the MAP, and is
labeled RSA key. If the MAP is already installed and operating, use the CLI
command display dap status command to display the fingerprint.
The fingerprint is used for secure communication between the WX switch
and the MAP, and applies only to Distributed MAPs.
and the MAP, and applies only to Distributed MAPs.
6 Click Next.
7 Select the MAP model from the MAP Model list.
8 To select the radio type for a single-radio model, click the MAP Radio Type
box and select the radio type from the list:
11a—802.11a
11b—802.11b only
11g—802.11b/g
9 Click Next.
10 Configure the radios:
a To enable the radio, select Enabled.
b In the Radio Profile list, select the profile to which the radio belongs.
c In the Channel Number list, select the channel number for the radio.
If RF Auto-Tuning for channel configuration is enabled, setting this value
has no effect. The channel number is controlled by RF Auto-Tuning.
has no effect. The channel number is controlled by RF Auto-Tuning.
d In the Transmit Power box, specify the transmit power for the radio.
If RF Auto-Tuning for power configuration is enabled, setting this value
has no effect. The power level is controlled by RF Auto-Tuning.
has no effect. The power level is controlled by RF Auto-Tuning.
e If the MAP has two radios, click Next and go to step 10. Otherwise,
go to step 11.
11 Click Finish.