Alinco dj-s17 e Benutzerhandbuch

4.Basic Operation

3. Press any key except for the MONI or FUNC key to complete setting.

In conventional repeater systems, a signal received on one frequency is retransmitted

on another frequency. The difference between these two frequencies is called the

offset frequency. The selectable offset frequency of this unit is from 0 to 99.995MHz.

The TX frequency can be shifted in the plus or minus direction based on the RX

frequency when the PTT key is pressed. This direction is called the shift direction.

You can set the shift direction and offset frequency in the Set mode. Refer to "Set

Mode Operation" on page 42 and "Entering the Set Mode" on page 43. To operate the

Repeater-Access function, use the Repeater-Access function memory. Refer to

"Programming a Repeater-Access Function Setting" on page 28.

1. Select the menu 10 in the Set mode to display the current shift direction setting.

2. Rotate the dial to select the desired shift direction.

A (-) means that the TX frequency is lower than the RX frequency.

A (+) means vice versa.

3. Press any key except for the MONI or FUNC key to complete setting.

SFD-OF

SFD- –

SFD- +

■

• Refer to "Set Mode Operation" on page 42 for the list of parameters that can

be programmed in the Set mode and "Entering the Set Mode" on page 43 to
enter the Set mode.

• Tuning step can't be changed in the Memory mode.
• When the tuning step is changed from 5kHz,10kHz,15kHz,20kHz or 30kHz to

12.5kHz and 25kHz or vice versa, the operating frequency and the shift width
automatically suit to the new setting.