australian-monitor amis120p Datenbogen

Power Output

120 Watts RMS

Maximum Load

80 Ohms @ 100 Volts

Power Bandwidth

60Hz - 15kHz < 0.5% THD

Frequency Response

60Hz - 15kHz (± 3dB)

Total Harmonic Distortion

0.5% @ 1kHz rated power

Signal To Noise Ratio

-80dB 

Input Sensitivity

700mV

Outputs

100V, 70V, 4 Ohm, 8 Ohm

Controls

One gain control on rear of the unit via flathead screwdriver control

Indicators

Power “on” LED

Power Source

AC 230/240V - 50Hz; DC 24V; 110V - 60Hz (special) 3 pin IEC connector

Power Consumption

300 Watts

Protection

Current Limiter protection, plus AC and DC fuses

Dimensions/Weight

88mm H x 480mm W x 280mm D (Chassis Dimensions only). 12kg

Rack Mounting

Standard

Engineered and Distributed By AUDIO TELEX COMMUNICATIONS PTY LTD (

ABN 78 001 345 482

), 149 Beaconsfield Street, Silverwater, Sydney, NSW, 2128 Australia

NSW Tel: (02) 9647 1411 Fax: (02) 9648 3698   VIC Tel: (03) 9890 7477 Fax: (03) 9890 7977   QLD Tel: (07) 3852 1312 Fax: (07) 3252 1237   WA Tel: (08) 9228 4222 Fax: (08) 9228 4233   

SA Tel: (08) 8352 4444 Fax: (08) 8352 4488   NZ Tel: (09) 415 9426 Fax: (09) 415 9864 Export Enquiries: export@audiotelex.com.au   

Website: www.australianmonitor.com.au

ARCHITECTURAL AND ENGINEERING SPECIFICATIONS

The 120 watt power amplifier shall be designed to run 100 and 70 volt line audio systems. The unit shall

also feature a 4 and 8 ohm output. The amplifier may be desk or rack mounted.

The amplifier must be capable of delivering 120 watts into an 80 ohm inductive load with less than 0.5%

distortion measured at 1kHz and with system hum and noise of -80dB or better. Internal current limit-

ing shall protect the amplifier from both overload and overdrive conditions.

The amplifier shall be an Australian Monitor Installation Series model AMIS120P.