australian-monitor amis pre1 Benutzerhandbuch

 

 

 

 

 

 

The Australian Monitor Installation Series PRE1 is a high quality, low cost mic 

preamp, that is highly featured & simple to use. The AMIS PRE1 features 
balanced XLR & unbalanced 6.35mm jack inputs & outputs, switchable 36 
volt phantom power, gain control &  signal  clip  LED.  Powered  by  a 
supplied 12VDC power supply, the AMIS PRE1 is an inexpensive mic 
preamp & phantom power supply & as part of the AMIS Contractor Tools 
range, has a multitude of uses in a wide variety of installations. 
 

 

 

•  Jack/XLR Mic Inputs: These inputs can be either unbalanced 

6.35mm jack or balanced XLR. Note Phantom power is available on 
the XLR input only. 

•  Jack/XLR Mic Outputs: These can be balanced XLR or unbalanced 

6.35mm jack outputs. Note  the 6.35mm output jack can also be 
connected to headphones for personal monitoring. 

•  12VDC Power input: This input accepts power from the supplied 

12VDC power supply. Note that the tip is Negative. 

•  Power LED: This LED indicates the unit is “on” 
•  Phantom Power On/Off: This switch enables 36 volt phantom power 

to the XLR input. 

•  Clip LED: This indicates that signal level is too high & distortion may 

occur 

•  Mic Gain: This increases the level of the microphone from the PRE1 

 

 
 Input 

 10K Ohm Balanced, unbalanced