australian-monitor amis250p Broschüre

Power Output

250 Watts RMS

Maximum Load

40 Ohms @ 100 Volts

Power Bandwidth

60Hz - 15kHz < O.5% THD

Frequency Response

60Hz - 15kHz (± 3dB)

Total Harmonic Distortion

0.5% @ 1 kHz rated power

Signal To Noise Ratio

-80dB 

Input Sensitivity

700mV

Outputs

100V, 70V, 4 Ohm

Controls

One gain control on rear of the unit via flathead screwdriver control

Indicators

Power “on” and “Protect” LED

Power Source

AC 230/240V - 50Hz; DC 24V; 110V - 60Hz (special) 3 pin IEC connector

Power Consumption

400 Watts

Protection

Current Limiter protection, plus AC and DC fuses

Dimensions/Weight

88mm H x 480mm W x 330mm D (Chassis Dimensions only). 15kg

Rack Mounting

Standard

Engineered and Distributed By AUDIO TELEX COMMUNICATIONS PTY LTD (

ABN 78 001 345 482

), 149 Beaconsfield Street, Silverwater, Sydney, NSW, 2128 Australia

NSW Tel: (02) 9647 1411 Fax: (02) 9648 3698   VIC Tel: (03) 9890 7477 Fax: (03) 9890 7977   QLD Tel: (07) 3852 1312 Fax: (07) 3252 1237   WA Tel: (08) 9228 4222 Fax: (08) 9228 4233   

SA Tel: (08) 8352 4444 Fax: (08) 8352 4488   NZ Tel: (09) 415 9426 Fax: (09) 415 9864 Export Enquiries: export@audiotelex.com.au   

Website: www.australianmonitor.com.au

ARCHITECTURAL AND ENGINEERING SPECIFICATIONS

The 250 watt power amplifier shall be designed to run 100 volt line audio systems. The unit shall also

features a four ohm output. The amplifier may be desk or rack mounted.

The unit shall feature high temperature protection with front panel indication. An in built auto temper-

ature sensing fan shall cool the unit when required and automatically turn off again once the amplifier

is running at the correct temperature. The amplifier must be capable of delivering 250 watts into a forty

ohm inductive load with less than 0.5% distortion measured at 1kHz and with system hum and noise

less than -74dB.

The amplifier shall be an Australian Monitor Installation Series model AMIS250P.