Autotek autocad raster design 2010 Benutzerhandbuch
You can specify the offset distance by clicking a through point, drawing a line
segment, or entering a numeric offset value. This offset distance is used as the
default value for the next use of the offset command in this editing session.
segment, or entering a numeric offset value. This offset distance is used as the
default value for the next use of the offset command in this editing session.
To create an offset from a REM object
1 Click Image menu ➤ Raster Entity Manipulation ➤ REM Operations
➤ Offset.
2 Specify the offset distance by entering a number, drawing a line, or
entering t then picking a through point.
3 Click the REM object to offset.
4 Optionally, click the side of the object where you want the offset, or click
the through point.
The offset object is drawn.
Quick Reference
Menu
Image ➤ Raster Entity Manipulation ➤ REM Operations ➤ Offset
REM Toolbar
Command Line
ioffset
Smoothing REM Linework
Runs a series of thinning and thickening filters on the raster linework of one
or more REM objects.
or more REM objects.
NOTE If you are editing REM lines by trimming, extending, or other operations,
you should finish all such editing before smoothing. After smoothing, you can get
unpredictable results with other editing operations.
you should finish all such editing before smoothing. After smoothing, you can get
unpredictable results with other editing operations.
The Smooth operation applies only to the REM objects you select. By contrast,
the smoothing filter available in the bitonal filters applies to the entire image.
For more information, see
the smoothing filter available in the bitonal filters applies to the entire image.
For more information, see
(page 112).
194 | Chapter 7 Raster Entity Manipulation