HP laserjet 2015 series Servicehandbuch
Reset the printer
NVRAM initialization
CAUTION
Only perform the following procedure if absolutely necessary. Performing an
NVRAM initialization resets some parameters that cannot be restored later.
NVRAM initialization sets all default variables stored in NVRAM back to factory default values or to a
default ROM value, depending on the variable. It also performs a system reset.
default ROM value, depending on the variable. It also performs a system reset.
NVRAM initialization resets the following:
ł
All menu settings to factory default values
ł
Factory settings such as formatter number, page counts, and factory paper settings
Use the following procedure to perform an NVRAM initialization.
1.
Turn the printer off.
2.
Press and hold down the
Go
button.
3.
Turn the printer on, and continue to hold the
Go
button for at least 20 seconds. During this
process, the
Go
button, Attention, and Ready LEDs each turn on.
4.
Release the
Go
button.
The printer lights begin cycling. After the NVRAM initialization is complete, the printer returns to the
ready state.
ready state.
Super NVRAM initialization
This feature is similar to NVRAM initialization, except all of NVRAM is re-initialized (including the
configuration parameters not reset by an NVRAM initialization).
configuration parameters not reset by an NVRAM initialization).
Use the following procedure to perform an NVRAM initialization.
1.
Turn off the printer.
2.
Press and hold the
Go
button.
3.
Turn on the printer and continue to hold the
Go
button for at least 50 seconds. During this
process, the
Attention
,
Ready
,
Go
lights turn on. Then the
Attention
and
Ready
lights turn off,
leaving only the
Go
light illuminated.
4.
Release the
Go
button. The
Go
,
Ready
and
Attention
lights turn on.
5.
Press and hold the
Go
button. All lights turn off. During the next three seconds, the
Go
,
Ready
and
Attention
lights turn on in that order, one per second.
6.
Release the
Go
button to perform the initialization. The control panel lights begin cycling from
front to back. After the Super NVRAM initialization process is complete, the printer returns to the
ready state.
ready state.
ENWW
Reset the printer
177