HP pavilion ze5100 Servicehandbuch
Troubleshooting and Maintenance
Troubleshooting Your Computer
Troubleshooting Your Computer
114
Reference Guide
Startup Problems
If the computer doesn’t respond when you turn it on
•
Connect the AC adapter.
•
Press the power button to try turning on the unit.
•
Reset the computer by inserting the tip of a ballpoint pen into the reset button on the
bottom of the computer. Then press the power button to turn it on.
bottom of the computer. Then press the power button to turn it on.
•
If the computer still doesn’t respond, remove the battery and AC adapter, remove any
PC cards, and undock the computer if docked. Then plug in the AC adapter again, and
reset the computer using the reset button.
PC cards, and undock the computer if docked. Then plug in the AC adapter again, and
reset the computer using the reset button.
If the computer won’t boot from battery power
•
Make sure the battery is properly inserted and fully charged. Check the battery’s
charge by removing it and pressing the pad on the side of the battery. The lights show
the charge level.
charge by removing it and pressing the pad on the side of the battery. The lights show
the charge level.
•
If available, try another battery.
If the computer won’t boot from the floppy disk drive
•
Make sure the floppy disk drive is selected as the boot device—see “To change the
boot device” on page 30.
boot device” on page 30.
•
If you’re using a USB floppy drive, use the BIOS Setup utility to make sure Legacy
USB Support is enabled—see “To run the BIOS Setup utility” on page 118
USB Support is enabled—see “To run the BIOS Setup utility” on page 118
If the computer stops responding after booting
•
Check whether you are connected to a TCP/IP network with no DHCP server. This
can cause a long delay at startup because DHCP is enabled. Contact your network
administrator to determine the proper TCP/IP configuration.
can cause a long delay at startup because DHCP is enabled. Contact your network
administrator to determine the proper TCP/IP configuration.
If the computer takes a long time to resume after being suspended
•
The computer can routinely take a minute or more to resume if it has a network card
installed. While the operating system is loading drivers and checking hardware and
network connections, you will see a blinking cursor on your display. As soon as the
hardware has been re-initialized, the Windows desktop will appear.
installed. While the operating system is loading drivers and checking hardware and
network connections, you will see a blinking cursor on your display. As soon as the
hardware has been re-initialized, the Windows desktop will appear.