HP photosmart 2700 Benutzerhandbuch

More than one supply item is low.

Check the supply-level gauges on the control
panel, or print a supplies status page to
determine which cartridges are low. See

Order the identified print cartridges. Printing
will continue until Replace <color>
cartridge appears.

 for more

information.

Press 

OK

The printer cannot process the page.

Press 

OK

 to continue printing the job, but

output might be affected.

The print cartridge is empty.

Replace the print cartridge. See 

.

More than one print cartridge is empty.

Check the supply-level gauges on the control
panel, or print a supplies status page to
determine which cartridges are empty. See

Replace the cartridges. See 

The printer has experienced an error with the
top-of-page sensor.

Turn off the power by using the power switch,
wait at least 30 seconds, and then turn on the
power and wait for the printer to initialize.

If you are using a surge protector, remove it.
Plug the printer directly into the wall socket.
Use the power switch to turn on the printer.

If the message persists, contact HP support.
See 

.

A new, non-HP supply has been installed.
This message appears until an HP supply is
installed or you press 

OK

.

If you believe you purchased an HP supply,
go to 

Service or repairs that are required as a result
of using non-HP supplies are not covered
under HP warranty.

To continue printing, press 

OK

.

A non-HP supply is installed, and you
pressed 

OK

 to override the error message.

If you believe you purchased an HP supply,
go to 

Service or repairs that are required as a result
of using non-HP supplies are not covered
under HP warranty.

The printer has detected print media in the
tray that does not match the configuration for
the tray.

Load the correct media into the tray, or
configure the tray for the size that you have
loaded. See 

ENWW

Control-panel messages

93