HP procurve 2500 Benutzerhandbuch
140
Enhancements in Release F.04.08
Configuring Rapid Reconfiguration Spanning Tree (RSTP)
CLI: Configuring RSTP
Viewing the Current Spanning Tree Configuration.
Even if Spanning Tree is disabled (the
default configuration), the
show spanning-tree config command lists the switch’s full Spanning Tree
configuration, including whole-switch and per-port settings.
Syntax: show spanning-tree configuration
Abbreviation:
sho span config
In the default configuration, the output from this command appears similar to the following:
Spanning Tree Commands in This Section
Applicable
Protocol
Version
Protocol
Version
Location
show spanning-tree config
both
Below on this page
spanning-tree
both
protocol-version <rstp | stp>
both
force-version <rstp-operation | stp-compatible>
RSTP
page 142
forward-delay <4 - 30>
both
page 142
hello-time <1 - 10>
both
page 142
maximum-age <6 - 40>
both
page 142
priority <0 - 15 | 0 - 65535>
RSTP | STP
page 142
<[ethernet] port-list>
both
page 143
path-cost <1 - 200 000 000>
both
page 144
priority <0 - 15 | 0 - 65535>
RSTP | STP
page 144
edge-port
RSTP
page 144
point-to-point-mac
RSTP
page 144
mcheck
RSTP
page 144
mode <norm | fast>
STP
See the Switch Management and Configuration
Guide for information on STP.
Guide for information on STP.
show spanning-tree
This command lists additional RSTP/STP monitoring data that is
not covered in this section. See “Spanning Tree Protocol Infor-
mation” in the “Monitoring and Analyzing Switch Operation”
chapter in your Switch Management and Configuration Guide.
not covered in this section. See “Spanning Tree Protocol Infor-
mation” in the “Monitoring and Analyzing Switch Operation”
chapter in your Switch Management and Configuration Guide.