HP procurve 2500 Benutzerhandbuch

    230

The startup-config file saved under version F.02.02 is NOT backward-compatible with previous 
software versions. HP recommends that you save a copy of the pre-02.02 startup-config file BEFORE 
UPGRADING to F.02.02 or greater, in case there is ever a need to revert back to pre-02.02 software. 
Instructions for saving a copy of the startup-config file are found in the "Transferring Switch 
Configurations" section of  Appendix A in the Management and Configuration Guide available for 
the switch.

■

After switch is rebooted, the port counters contain an incorrect 

large value.

■

If the transceiver speed-senses from 1000 Mbps to 100 Mbps 

(or the reverse), the port incorrectly stays at the previous speed (i.e., speed mismatch) while 
the switch incorrectly shows linkbeat for that port. [Fix is to have the switch not establish 
linkbeat.  The switch must be rebooted in order to establish linkbeat after the transceiver 
speed-senses from 1000 Mbps to 100 Mbps or vice versa.]

■

If switch's gateway is the same as its own IP address, switch cannot ping off-net and 

"show arp" output does not include gateway, after pinging the configured gateway.

■

The output of the 

 command from the operator level context lists commands 

that are unavailable due to insufficient privileges and the output of the 

 

command does not properly align the trunk designations within the 

 column.

■

When a config is reloaded that was saved off from a switch, it does not match the 

config offloaded as follows:

a.

  SNMP community parameter 

 is changed to 

.

b.

 

 commands are added to the VLAN configuration.

■

If an active port is configured as disabled and, while the port is disabled its trunk 

membership is changed, the switch console becomes inaccessible.

■

The fault-finder configuration as reported by 

 or 

 does 

not correctly display the type of alarm.

■

The 

 parameter changes from 

 to 

 on the default VLAN when 

trying to add a new VLAN address that is the same (i.e., duplicate) as the DHCP-acquired IP 
address of the default VLAN. [Fix is: error message is generated when the user attempts to 
configure a duplicate IP address.]