Canon imageclass mf4150 Betriebsanweisung
1
2
3
4
5
6
Back
4-4
● RESULT: Result of transaction
– OK: Transmission successful
– NG: Transmission failed
– STOP: Transmission manually canceled before completion
– MEM.FULL: Memory became full during transmission
– NO ANSWER: Call not answered
– PAPER JAM: ADF jam occurs during Manual TX
● Error code: For descriptions of error codes, see Chapter
11, “Troubleshooting,” in the Basic Guide.
NOTE
ERROR TX REPORT or MULTI TX REPORT is printed out depending
on the transmission result.
on the transmission result.
■
RX REPORT
1.
Press [Additional Functions].
2.
Use [
] or [
] to select <REPORT
SETTINGS>, then press [OK].
3.
Use [
] or [
] to select <SETTINGS>,
then press [OK].
4.
Use [
] or [
] to select <RX REPORT>,
then press [OK].
5.
Use [
] or [
] to select the setting you
want, then press [OK].
<OUTPUT NO>: Does not print a report.
<OUTPUT YES>: Prints a report every time you receive a
document.
<PRINT ERROR ONLY>: Prints a report only when a reception
error occurs.
<OUTPUT YES>: Prints a report every time you receive a
document.
<PRINT ERROR ONLY>: Prints a report only when a reception
error occurs.
6.
Press [Stop/Reset] to return to the standby
mode.
mode.
Report Items
The following items are displayed in the Reception Result
Report:
Report:
● JOB NO.: Job number
● TYPE: Type of reception
● TYPE: Type of reception
– RX: Memory or print reception
● NO.: Sequence number
● DESTINATION TEL/ID: Number of the sending machine
● DESTINATION TEL/ID: Number of the sending machine
(displayed only if registered in their machine)
● DATE: Date of transaction
● TIME: Time of transaction
● PAGE: Number of pages received
● TIME USE: Amount of time taken for a transaction
● MODE: Mode of transaction (G3 or ECM)
● TIME: Time of transaction
● PAGE: Number of pages received
● TIME USE: Amount of time taken for a transaction
● MODE: Mode of transaction (G3 or ECM)