Canon multipass l6000 Benutzerhandbuch

Chapter 10

Troubleshooting

MP L6000—USERS MANUAL/V000/12-97

The 

ALARM

light

The MultiPASS may have a 

Clear any paper jams. See 

comes on and the 

paper jam.

page 10-3.

MultiPASS L6000

beeps while printing

If you cannot clear the 

problem, unplug the

MultiPASS, wait 15 seconds,

then plug it in again. (You will

lose any documents stored in

memory.) If the problem is

fixed, the 

ALARM

light will be

off and the LCD display will

show the date and Receive

Mode (Standby Mode).
If the 

ALARM

light stays on,

call the Customer Care Center.

See page 1-2.

Data from computer is 

The power cord may not

Check that the power cord is

not printed

be plugged in securely.

plugged securely into the unit

and into the wall outlet. If the

MultiPASS is plugged into a

power strip, make sure the

power strip is plugged in and

turned on.

The interface cable may not

Check the interface cable 

be securely connected to the 

connection.

MultiPASS and the computer.
The interface cable may 

Make sure the cable is a

not be the correct type.

bi-directional parallel interface

cable less than 6.6 feet (2 m) in

length.

The MultiPASS or computer

Unplug the MultiPASS and

may have been turned on

turn off the computer. Plug

when you connected the

the unit back in and turn

interface cable.

the computer back on again.

The toner cartridge may need 

Rock the toner cartridge.  

to be replaced.  

See page 9-11.

The application you are 

Check the computer and the

printing from may not be 

application to make sure they 

set up properly.

are configured correctly.