Sony bravia kdl-40u2000 Benutzerhandbuch

 GB

Picture noise when viewing a 
TV channel

• Select “Manual Programme Preset” in the “Set-Up” menu and adjust “AFT” 

(Automatic Fine Tuning) to obtain better picture reception (page 19).

Some tiny black points and/or 
bright points on the screen

• The picture of a display unit is composed of pixels. Tiny black points and/or 

bright points (pixels) on the screen do not indicate a malfunction.

No colour on programmes

• Select “Reset” in the “Picture Adjustment” menu to return to the factory 

settings (page 16).

No colour or irregular colour 
when viewing a signal from the 
Y, P

B

/C

B

, P

R

/C

R

 jacks of 

3

• Check the connection of the Y, P

B

/C

B

, P

R

/C

R

 jacks of 

3.

• Make sure that the Y, P

B

/C

B

, P

R

/C

R

 jacks of 

3 are firmly seated in their 

respective sockets.

Irregular picture when viewing 
a signal from PC

• Check PC input socket connection.
• Connect to PC input socket instead of HDMI IN 6 socket.
• If the connection is only available through HDMI socket, change the screen 

resolution to 720p and adjust horizontal and vertical screen size in the 
display properties settings of PC.

No sound, but good picture

• Press 2 +/– or % (Mute).
• Check that “TV Speakers” is set to “On” in the “Sound Adjustment” menu 

(page 17).

Noisy sound

• See the “Picture noise” causes/remedies on page 25.

The desired channel cannot be 
selected

• Switch between digital and analogue mode and select the desired digital/

analogue channel.

Some channels are blank

• Scrambled/Subscription only channel. Subscribe to the Pay Per View 

service.

• Channel is used only for data (no picture or sound).
• Contact the broadcaster for transmission details.

Digital channel is not displayed

• Check that the aerial is plugged directly into the TV (not through other 

equipment).

• Contact a local installer to find out if digital transmissions are provided in 

your area.

• Upgrade to a higher gain aerial.

The TV turns off automatically 
(the TV enters standby mode)

• Check if the “Sleep Timer” is activated, or confirm the setting of “Off 

Time” (page 18).

• If no signal is received and no operation is performed in the TV mode for 

10 minutes, the TV automatically switches to standby mode.

The TV turns on automatically

• Check if the “On Time” is activated (page 18).

Some input sources cannot be 
selected

• Select “AV Preset” in the “Set-up” menu and cancel “Skip” of the input 

source (page 19).

The remote does not function

• Replace the batteries.