Sony HCD-HP7 Benutzerhandbuch
14
GB
To change the AM tuning interval
(except for European, Russian,
Middle Eastern and Philippine
models)
(except for European, Russian,
Middle Eastern and Philippine
models)
The AM tuning interval is factory-preset to 9
kHz (or 10 kHz for some areas). To change the
AM tuning interval, tune in any AM station first,
then turn off the system. While holding TUNER/
BAND on the unit, press ?/1 on the unit. When
you change the interval, all the AM preset
stations are erased. To reset the interval, repeat
the same procedure.
kHz (or 10 kHz for some areas). To change the
AM tuning interval, tune in any AM station first,
then turn off the system. While holding TUNER/
BAND on the unit, press ?/1 on the unit. When
you change the interval, all the AM preset
stations are erased. To reset the interval, repeat
the same procedure.
Note
You cannot change the AM tuning interval in the
Power Saving Mode.
Power Saving Mode.
Tips
• The preset stations are retained for about a day even
if you disconnect the power cord or if a power failure
occurs.
occurs.
• To improve the reception, adjust the supplied
antennas or connect an external antenna.
You can listen to a radio station either by
selecting a preset station, or by manually tuning
in the station.
selecting a preset station, or by manually tuning
in the station.
Listening to a preset station
— Preset Tuning
Preset radio stations in the tuner’s memory first
(see “Presetting radio stations” on page 13).
(see “Presetting radio stations” on page 13).
1
Press TUNER BAND repeatedly to
select “FM” or “AM”.
select “FM” or “AM”.
2
Press PRESET +/– repeatedly to select
the desired preset station.
the desired preset station.
Listening to non-preset radio
station
station
— Manual Tuning
1
Press TUNER BAND repeatedly to
select “FM” or “AM”.
select “FM” or “AM”.
2
Press TUNING +/– repeatedly to tune in
the desired station.
the desired station.
Tips
• To improve broadcast reception, adjust the supplied
antennas, or connect a commercially available
external antenna.
external antenna.
• When an FM stereo program has static noise, press
REPEAT/FM MODE on the remote until “MONO”
appears. There will be no stereo effect, but the
reception will improve.
appears. There will be no stereo effect, but the
reception will improve.
• Press and hold TUNING +/–. The frequency
indication changes and scanning stops when the
system tunes in a station (Automatic Tuning).
system tunes in a station (Automatic Tuning).
• To record the radio programs, use manual recording
Listening to the radio
Frequency
Preset number