Sony HTST7 Benutzerhandbuch
10
US
2
Place the IR blaster close to the remote control sensor of the
TV, aiming the IR emitter of the IR blaster at the remote
control sensor of the TV.
TV, aiming the IR emitter of the IR blaster at the remote
control sensor of the TV.
Refer to the operating instructions of your TV for the location of the
remote control sensor.
remote control sensor.
Connect the IR blaster before connecting the AC power cord (mains lead)
of the Bar SPEAKER.
of the Bar SPEAKER.
Do not connect the IR blaster to a headphone jack, etc. of the TV.
Do not use the IR blaster for any other purposes.
Make sure that the IR repeater function is working before securing the IR
blaster on the Bar Speaker with the double-faced adhesive tape supplied.
blaster on the Bar Speaker with the double-faced adhesive tape supplied.
Location of the IR blaster may vary depending on the product you are
using.
using.
3
Press MENU on the remote control of the system.
(Refer to “Adjusting the settings” in the Operating Instructions.)
(Refer to “Adjusting the settings” in the Operating Instructions.)
4
Select “SYSTEM” with
/, then press ENTER.
5
Select “IR REP.,” then press ENTER.
6
Select “ON,” then press ENTER.
7
Press MENU.
The menu turns off.
The menu turns off.
Be sure to check that the remote control of the TV cannot control the TV,
then set “IR REP.” to “ON.” If it is set to “ON” when the remote control can
control the TV, appropriate operation may not be obtained, because of
the interference between the direct command from the remote control
and the command via the Bar Speaker.
then set “IR REP.” to “ON.” If it is set to “ON” when the remote control can
control the TV, appropriate operation may not be obtained, because of
the interference between the direct command from the remote control
and the command via the Bar Speaker.
On some TVs, this function may not work. In this case, adjust the position
of the IR blaster or the Bar Speaker.
of the IR blaster or the Bar Speaker.
Enabling the Secure Link function
You can specify the wireless connection to be used to link the Bar
Speaker to the subwoofer using the Secure Link function. This function
is useful when you use multiple wireless products.
Speaker to the subwoofer using the Secure Link function. This function
is useful when you use multiple wireless products.
1
Press MENU on the remote control.
(Refer to “Adjusting the settings” in the Operating Instructions.)
(Refer to “Adjusting the settings” in the Operating Instructions.)
2
Select “WS” with
/, then press ENTER.
3
Select “SEC. ON,” then press ENTER.
Notes
Notes
SECURE LINK
indicator