Sony ICF-C7IP Benutzerhandbuch

To reduce the risk of fire, do not cover the 

ventilation of the apparatus with newspapers, 

tablecloths, curtains, etc. And do not place lighted 

candles on the apparatus.

To reduce the risk of fire or electric shock, do not 

expose this apparatus to dripping or splashing, 

and do not place objects filled with liquids, such 

as vases, on the apparatus.
Do not install the appliance in a confined space, 

such as a bookcase or built-in cabinet.
Do not expose the batteries (battery pack or 

batteries installed) to excessive heat such as 

sunshine, fire or the like for a long time.
As the main plug is used to disconnect the unit 

from the mains, connect the unit to an easily 

accessible AC outlet. Should you notice an 

abnormality in the unit, disconnect the main plug 

from the AC outlet immediately.

Danger of explosion if battery is incorrectly 

replaced. Replace only with the same or 

equivalent type.
Notice for customers: the following 

The manufacturer of this product is Sony 

Corporation, 1-7-1 Konan, Minato-ku, Tokyo, 

108-0075 Japan. The Authorized Representative 

for EMC and product safety is Sony Deutschland 

GmbH, Hedelfinger Strasse 61, 70327 Stuttgart, 

Germany. For any service or guarantee matters, 

please refer to the addresses given in separate 

service or guarantee documents.

 Wake or sleep to iPod/Radio

 Dual Alarm

 FM/AM 2-band digital synthesized tuner

 30 Station Presets (20 FM. 10 AM)

 Brightness Control (High/Mid/Low)

 Extendable Snooze system from 10 to 60 min

 No Power No Problem alarm system to keep 

the clock and the alarm operating during a 

power interruption with a CR2032 battery 

installed

 Operate the unit on the power source specified 

in “Specifications.”

 To disconnect the AC power cord (mains lead), 

pull it out by the plug, not the cord.

 The unit is not disconnected from the AC 

power source (mains) as long as it is connected 

to the wall outlet, even if the unit itself has been 

turned off.

 Since a strong magnet is used for the speaker, 

keep personal credit cards using magnetic coding 

or spring-wound watches away from the unit to 

prevent possible damage from the magnet.

 Do not leave the unit in a location near a heat 

source such as a radiator or airduct, or in a 

place subject to direct sunlight, excessive dust, 

mechanical vibration, or shock.

 Allow adequate air circulation to prevent 

internal heat build-up. Do not place the unit on 

a surface (a rug, a blanket, etc.) or near 

materials (a curtain) which might block the 

ventilation holes.

 Should any solid object or liquid fall into the unit, 

unplug the unit and have it checked by qualified 

personnel before operating it any further.

 To clean the casing, use a soft cloth dampened 

with a mild detergent solution.

 Never touch the wire of the external FM aerial 

during a thunderstorm. Furthermore, 

immediately disconnect the AC power cord 

from the radio.

 Wipe the battery with a dry cloth to assure a 

good contact.

 Be sure to observe the correct polarity when 

installing the battery.

 Do not hold the battery with metallic tweezers, 

otherwise a short-circuit may occur.

DC out: 5V

MAX: 500mA

FM

87.5 MHz – 108 MHz 0.05 MHz

AM

531 kHz – 1 602 kHz 9 kHz

Approx. 3.8 cm (1 

1

/

2

 inches) dia. 8 Ω

AUDIO IN jack (ø 3.5 mm stereo minijack)
Power output

0.8 W (at 10% harmonic distortion)
Power requirements

230 V AC, 50 Hz

For clock back up: 3V DC, one CR2032 battery

Approx. 115 mm × 124.7 mm × 97.1 mm (w/h/d)  

(4 

9

/

16

 inches × 4 

15

/

16

 inches × 3 

7

/

8

 inches) not 

including projecting parts and controls
Mass

Approx. 520 g (1 lb 2.3 oz) including power 

supply unit
Supplied accessories

Remote commander (1)

AM loop aerial (1)

Audio connecting cable (1)

Universal Dock Adapter for iPhone (1)

Universal Dock Adapter for iPhone 3G & iPhone 

3GS (1)

Universal Dock Adapter for iPhone 4 (1)
Design and specifications are subject to change 

without notice.

Compatible iPod/iPhone models are as follows. 

Update your iPod/iPhone to use the latest 

software before you use it.

iPod touch

3rd generation

iPod touch

2nd generation

iPod touch 

1st generation

iPod nano  

5th generation 

(video camera)

iPod nano  

4th generation  

(video) 

iPod nano  

3rd generation 

(video)

iPod nano  

2nd generation 

(aluminum)

iPod nano  

1st generation

iPod  

5th generation 

(video)

iPod  

4th generation  

(color display)

iPod  

4th generation 

iPod classic

iPod mini 

iPhone 4

iPhone 3GS

iPhone 3G

iPhone

4-139-836-94(1)

To keep accurate time, this unit contains a 

CR2032 battery inside of the unit as a backup 

power source.

The battery keeps the clock operating in the event 

of a power interruption.
Note for customers in the UK

The clock is preset at the factory, and its memory 

is powered by the preinstalled Sony CR2032 

battery. If the “AM 12:00” appears in the display 

when the unit is connected to AC outlet for the 

first time, the battery may be weak. In this case, 

consult a Sony dealer. The preinstalled CR2032 

battery is considered part of the product, and is 

covered by the warranty. 

You are required to show “Note for customers in 

the UK” (in this instruction) to a Sony dealer in 

order to validate the warranty for this product.

When the battery becomes weak, “” appears in 

the display.

If a power interruption occurs while the battery is 

weak, the current time and alarm will be erased.

Replace the battery with a Sony CR2032 lithium 

battery. Use of another battery may cause a fire or 

explosion.

  Keep the AC plug connected to the AC 

outlet, remove the screw that secures the 

battery holder at the bottom of the unit 

using a screwdriver, and remove the 

battery holder.

  Replace a new battery in the battery holder 

with the  side facing up.

  Insert the battery holder back into the 

unit and secure it with the screw.

  Press iPod & iPhone , RADIO 

BAND, AUDIO IN or SNOOZE/DATE/

SLEEP OFF to turn “



” off in the 

display.

When you replace the battery, do not disconnect 

the plug from the AC outlet. Otherwise, the 

calendar, current time, alarm and station presets 

will be erased.







Press the Reset button with a pointed device. The 

Reset button is in the small hole located near the 

battery holder. 

Notes
 In these Operating Instructions, “iPod” is used 

as a general reference to functions of iPod on an 

iPod or iPhone, unless otherwise specified by 

the text or illustrations.

 The connector of the unit is for sole use with an 

iPod. If you use devices that do not match with 

the connector, connect to the AUDIO IN 

terminal of this unit with the supplied audio 

connecting cable.

 Sony cannot accept responsibility in the event 

that data recorded to an iPod is lost or damaged 

when using an iPod connected to this unit.

The shape and the length of the aerial is designed 

to receive AM signals. Do not dismantle or roll up 

the aerial.

  Remove only the loop part from the 

plastic stand.

  Set up the AM loop aerial.

  Connect the cords to the AM aerial 

terminals.

Cord (A) or cord (B) can be connected to 

either terminal.

  Make sure the AM loop aerial is 

connected firmly by pulling softly.

Find a place and an orientation that provide good 

reception.

 Do not place the AM loop aerial near the unit 

or other AV equipment, as noise may result.

Adjust the direction of the AM loop aerial for best 

AM broadcast sound.

Before using the card remote commander for the 

first time, remove the insulation film.

With normal use, the battery (CR2025) should 

last for about six months. When the remote 

commander no longer operates the unit, replace 

the battery with a new one.



Notes
 Do not attempt to charge the battery.

 If you are not going to use the remote 

commander for a long time, remove the battery 

to avoid any damage that may be caused by 

leakage and corrosion.

©2009 Sony Corporation          

Printed in China

FM/AM

Clock Radio

Operating Instructions

ICF-C7iP

Dream Machine is a trademark of Sony Corporation.

This symbol on the product or on its packaging 

indicates that this product shall not be treated as 

household waste. Instead it shall be handed over 

to the applicable collection point for the recycling 

of electrical and electronic equipment. By 

ensuring this product is disposed of correctly, you 

will help prevent potential negative consequences 

for the environment and human health, which 

could otherwise be caused by inappropriate waste 

handling of this product. The recycling of 

materials will help to conserve natural resources. 

For more detailed information about recycling of 

this product, please contact your local Civic 

Office, your household waste disposal service or 

the shop where you purchased the product.

This symbol on the battery or on the packaging 

indicates that the battery provided with this 

product shall not be treated as household waste.

On certain batteries this symbol might be used in 

combination with a chemical symbol. The 

chemical symbols for mercury (Hg) or lead (Pb) 

are added if the battery contains more than 

0.0005% mercury or 0.004% lead.

By ensuring these batteries are disposed of 

correctly, you will help prevent potentially 

negative consequences for the environment and 

human health which could otherwise be caused 

by inappropriate waste handling of the battery. 

The recycling of the materials will help to 

conserve natural resources.
In case of products that for safety, performance or 

data integrity reasons require a permanent 

connection with an incorporated battery, this 

battery should be replaced by qualified service 

staff only.

To ensure that the battery will be treated properly, 

hand over the product at end-of-life to the 

applicable collection point for the recycling of 

electrical and electronic equipment.
For all other batteries, please view the section on 

how to remove the battery from the product 

safely. Hand the battery over to the applicable 

collection point for the recycling of waste 

batteries.
For more detailed information about recycling of 

this product or battery, please contact your local 

Civic Office, your household waste disposal 

service or the shop where you purchased the 

product.
If you have any questions or problems concerning 

your unit, please consult your nearest Sony dealer.

Should any problem persist after you have made 

the following checks, consult your nearest Sony 

dealer.
The clock flashes “AM12:00” due to a power 

interruption.
 The battery is low. Replace the battery. Remove 

the old battery and install a new one.

sound at the preset alarm time.
 Check that alarm “A” or alarm “B” is properly 

displayed. 

sound comes on at the preset alarm time.
 Check the alarm volume setting.
There is no sound from the iPod.
 Make sure the iPod is securely connected.

 Adjust the VOLUME.
The iPod cannot be operated with this unit.
 Make sure the iPod is securely connected.
The iPod cannot be charged.
 Make sure the iPod is securely connected.
When daylight saving time begins, the clock 

automatically.
 Make sure the clock is set correctly.

 Press and hold CLOCK and SNOOZE/DATE/

SLEEP OFF simultaneously for at least  

2 seconds to activate the Automatic DST 

function.

No Power No Problem is a trademark of Sony Corporation.