Sony LMD-1041 Benutzerhandbuch
4
Functions of Controls
Front • Top
1 INDEX button
Shows the index number of the unit (page 11).
You can assign an index number to each unit. When
two or more units are installed at the same location, use
this index number to select a unit you want to control
using the remote commander.
You can assign an index number to each unit. When
two or more units are installed at the same location, use
this index number to select a unit you want to control
using the remote commander.
2 U SCAN (under scan) button
Switches the size and viewable area of the image.
3 Adjusting parameter button
After selecting a parameter with these buttons, adjust
with the +/– buttons 4.
Adjusting parameters differs depending on the input
signal. See the table on the next page.
with the +/– buttons 4.
Adjusting parameters differs depending on the input
signal. See the table on the next page.
V POS button
Adjusts the picture position in the vertical direction for
the computer signal.
the computer signal.
H PH button
Corrects the jitter, unclear characters and color bleeding
caused by the horizontal phase difference for the
computer signal and the video signal.
caused by the horizontal phase difference for the
computer signal and the video signal.
H SIZE button
Adjusts the picture size in the horizontal direction for
the computer signal and the video signal in under-scan
mode.
the computer signal and the video signal in under-scan
mode.
H POS button
Adjusts the picture position in the horizontal direction
for the computer signal and the video signal in under-
scan mode.
for the computer signal and the video signal in under-
scan mode.
SHARP button
Adjusts the picture sharpness for the LINE A, LINE B or
LINE C (YUV) signal.
LINE C (YUV) signal.
COLOR button
Adjusts the color density for the LINE A, LINE B or
LINE C (YUV) signal.
LINE C (YUV) signal.
HUE button
Adjusts the hue for the LINE A, LINE B or LINE C
(YUV) signal. Works with NTSC video signal only.
(YUV) signal. Works with NTSC video signal only.
PIC button
Adjusts the picture contrast for all signals.
LIGHT button
Adjusts the brightness of the screen (backlight). (The
LCD angle against field of view does not change.)
LCD angle against field of view does not change.)
BRT button
Adjusts the brightness of the screen. (The LCD angle
against field of view is adjusted.)
against field of view is adjusted.)
4 +/– buttons
Adjusts the selected parameter.
5 Signal input button
Selects the input signal.
LINE A button
Selects the video/audio signal input through the LINE
A connectors !ª.
A connectors !ª.
LINE B button
Selects the video/audio signal input through the LINE B
connectors !•.
connectors !•.
LINE C button
Selects the video/audio signal input through the LINE
C connectors !¶. Each time you press the button, the
RGB signal mode and YUV (Y/B-Y/R-Y) signal mode
switches. In the RGB signal mode, the computer mode
or the VIDEO RGB mode switches automatically
depending on the input signal.
C connectors !¶. Each time you press the button, the
RGB signal mode and YUV (Y/B-Y/R-Y) signal mode
switches. In the RGB signal mode, the computer mode
or the VIDEO RGB mode switches automatically
depending on the input signal.
Note on the computer signal
The characters may have colored shade in some horizontal
sizes. Adjust the H PH, H SIZE or H POS parameter so that
the shade disappears.
The characters may have colored shade in some horizontal
sizes. Adjust the H PH, H SIZE or H POS parameter so that
the shade disappears.