Sony md walkman mz-r55 Benutzerhandbuch

1 Press and slide REC to the right .

“REC” lights up and recording starts.

2 Play the CD or tape you want to

p.

“Data Save” or “Toc Edit” flashes while data
of the recording (the track’s start and end
points, etc.) is being recorded. Do not move
or jog the recorder or disconnect the power
source while the indication is flashing in the
display.

Pause

Record from the end of the
previous recording

Record partway through the
previous recording.

Remove the MD.

1)

A track mark is added at the point where you press 

P; thus the remainder of the track will be

counted as a new track.

2)

Once you open the lid, the point to start recording will change to the beginning of the first track.
Check the point to start recording on the display.

•Make sure the recorder is not locked (page

20).

•Make sure the MD is not record-protected

(page 30).

•Premastered MDs cannot be recorded over.

If the power supply is disrupted (i.e. the
battery is removed or becomes exhausted or
the AC power adaptor is disconnected)
when the recorder is operating, the lid will
not open until the power is restored.

p

P

1)

Press 

P again to resume recording.

END SEARCH and slide REC.

(, + or = to find the start point
of recording and press 

p to stop. Then

slide REC.

p and open the lid.

2)

z

•The level of the recorded sound is adjusted

automatically.

•You can monitor the sound during

recording. Connect the supplied
headphones with remote control to 

2/

REMOTE and adjust the volume by
pressing VOLUME +/– (VOL +/– on the
remote control). This does not affect the
recording level.