Elite Screens HOME135IWS2 Benutzerhandbuch
www.elitescreens.com
/ eliteinfo@elitescreens.com
2. Slide the Extruded Hanging Brackets (D) thru the rail located below the slide channel until it meets with the top part
of the bolts (B) and then slightly tighten the lug-nuts located on the top and bottom of the bolt with a wrench to secure the
extruded hanging brackets.
of the bolts (B) and then slightly tighten the lug-nuts located on the top and bottom of the bolt with a wrench to secure the
extruded hanging brackets.
3. Mark the location of where the screen is to be installed and drill your hole. Insert the proper screw into the drilled
hole and finish tightening the bolts to the bracket.
hole and finish tightening the bolts to the bracket.
Masonry Anchors and Bolts (C) are used on concrete/masonry wall/ceilings.
Plastic drywall anchors (A) are included for drywall mounting.
Wood screws (A) are to be used for wooden wall/ceiling studs on screen sizes less than or equal to 120” inches
(diagonal).
Masonry anchors (C) should be used for wall/ceiling installations of screen sizes greater than
120 inches (diagonal). We strongly advise to consult with a professional for such installation.
5. Examples of an installed CineTension 2 on a wall, ceiling and enclosed.
A
B
C
D
D
Top hole for ceiling installation
Back hole for wall installation
Flush mount
to wall
to wall
Flush mount
to
to
ceiling
Enclosed
installation
installation
*Allow 2” of spacing
between the front and
back of the screen casing.
between the front and
back of the screen casing.