Sony muteki lbt-zx99i Benutzerhandbuch

Repeat the procedure above and “CD 
POWER ON” appears in the display.

• When “CD POWER OFF” is selected, disc 

access time is increased.

• You cannot change the CD power manage 

setting in Power Saving Mode (page 27).

The factory setting for AM tuning interval 
is 10 kHz.
Use the buttons on the unit for the 
operation.

Press TUNER/BAND repeatedly to 
select AM band.

Press "/1 to turn off the system.

When demonstration appears, hold 
down TUNING MODE and then 
press "/1.
The system turn on automatically.
“AM 9K STEP” or “AM 10K STEP” 
appears in the display.

When you change the interval, all the AM 
preset stations are erased.

To improve broadcast reception, adjust the 
supplied antennas, or connect an external 
antenna.

Press FM MODE repeatedly until 
“MONO” lights up in the display. 
There will be no stereo effect, but the 
reception will improve.

You can listen to audio contents stored in 
the iPod on this system.

Press NX (or N on the 
remote) to start playback.

• When you connect an iPod to the unit, the 

iPod is automatically turned on if the system 

is turned on.

• When placing or removing the iPod, handle 

the iPod in the same angle as that of the iPod 

connector on the unit and do not twist or sway 

the iPod to prevent connector damage.

• Do not carry the unit with an iPod set on the 

connector. Doing so may cause a malfunction.

• When placing or removing the iPod, brace the 

unit with one hand and take care not to press 

the controls of the iPod by mistake.

• Before disconnecting the iPod, pause 

playback.

• Depending on the connected iPod, you may 

not able to use m or M while playing 

video. In this case, you can fast rewind or fast 

forward by holding down . or >.

• To change the volume level, use 

VOLUME +/–. The volume level does not 

change even if adjusted on the iPod.

• This iPod connector is designed for iPod only. 

You cannot connect any other portable audio 

players.