Sony SRX-T110 Benutzerhandbuch

18

Starting the SRX Controller

  Chap

te

r 2 

 Pr
epa

ra

tio
n

s

For safety, do not connect the connector for peripheral 
device wiring that might have excessive voltage to this 
port.  Follow the instructions for this port.

If the power of the projector remains on for a long period 
of time without the ethernet cable connected, the message 
“Sony Data Projector Initializing…” may appear in the 
STATUS MESSAGE window while you are setting up for 
networking after connecting the ethernet cable. This is not 
a malfunction of the projector.

Double-click the 

 icon for the SRX Controller in the 

desktop window of the computer.
The SRX Controller starts and the Program Launcher 
screen is displayed.

When the Operating System of the computer is Windows 
XP SP2 or later, or any commercially available firewall 
software is installed in your computer, the following may 
occur. In these cases, unblock the Windows firewall 
following the procedures below.

For Windows XP SP2 or later
If the dialog shown below appears when the SRX 
Controller is started, select “Unblock”. When the dialog 
does not appear but the computer does not access the 
projector, start “Windows Firewall” from “Control Panel”, 
and then add “SRX Controller” to the list in the 
“Exceptions” tab.

For commercially available firewall software
Add “SRX Controller” to the Exceptions list, referring to 
the operating instructions supplied with the software.

INTER LOCK ETHERNET

RS232C

RS232C connector

Connecting cable (not supplied)

Computer

RS-232C connector