Sony SRX-T110 Benutzerhandbuch
5
Precautions
Chapter
Chapt
er 1 Ov
e
rv
ie
w
1
Overview
Precautions
On safety
• Operate the unit on 200 – 240 V AC, 50/60 Hz (SRX-
T110), or 100 – 240 V AC, 50/60 Hz (SRX-T105).
• Should any liquid or solid object fall into the cabinet,
unplug the unit and have it checked by your Sony dealer
before operating it further.
before operating it further.
• Unplug the unit from the wall outlet or set the power
switch to the lower position if it is not to be used for
several days.
several days.
• To disconnect the cord, pull it out by the plug. Never pull
the cord itself.
• The wall outlet should be near the unit and easily
accessible.
• The unit is not disconnected from the AC power source
(mains) as long as it is connected to the wall outlet and
the power switch is set to the upper position.
the power switch is set to the upper position.
• Do not look into the lens while the lamp is on.
• Do not place your hand or objects near the ventilation
• Do not place your hand or objects near the ventilation
holes. The air coming out is hot.
• Have at least four people carry and handle the projector,
to avoid accidents or injury.
• Avoid using an extension cord with a low voltage limit,
as it may cause short-circuiting and physical injury.
• To carry the projector, be sure to use the carrying
handles. Do not hold other parts of the projector,
especially the lens, nor catch your finger between the
handle, floor, and the projector.
especially the lens, nor catch your finger between the
handle, floor, and the projector.
• Do not catch your finger between the unit and surface of
the floor when moving the projector installed on the
floor.
floor.
• Be careful not to catch your finger in the cooling fan.
• Since an intense light has come out of this projector from
• Since an intense light has come out of this projector from
the front, do not stand on the front of a projector for a
long time.
long time.
• Should the lamp explode, it is dangerous to be near the
ventilation holes for exhaust. Keep at least 2 m (approx.
6.6 feet) away from the projector’s ventilation holes for
exhaust.
6.6 feet) away from the projector’s ventilation holes for
exhaust.
Unit: mm (inches)
Unit: mm (inches)
On installation
• Allow adequate air circulation to prevent internal heat
build-up. Do not place the unit on surfaces (rugs,
blankets, etc.) or near materials (curtains, draperies) that
may block the ventilation holes. Leave space of more
than 100 cm (39
blankets, etc.) or near materials (curtains, draperies) that
may block the ventilation holes. Leave space of more
than 100 cm (39
3
/
8
inches) between the wall and the
2000
(78
(78
3
/
4
)
1000 (39
3
/
8
)
1000 (39
3
/
8
)
Dangerous area in case of lamp explosion
1000 (39
3
/
8
)
1000 (39
3
/
8
)
1000 (39
3
/
8
)
Exhaust
Exhaust area
Dangerous area in case of
lamp explosion
lamp explosion