Denon RCD-N7 Benutzerhandbuch

n

The lightning fl ash with arrowhead symbol, 
within an equilateral triangle, is intended 
to alert the user to the presence of 
uninsulated “dangerous voltage” within 
the product’s enclosure that may be of 
suffi cient magnitude to constitute a risk of 
electric shock to persons.

The exclamation point within an equilateral 
triangle is intended to alert the user to 
the presence of important operating and 
maintenance (servicing) instructions in the 
literature accompanying the appliance.

n Laser Class (IEC 60825-1:2001)

$-"44

-"4&3 130%6$5

 

1.  Read these instructions.
2.  Keep these instructions.
3.  Heed all warnings.
4.  Follow all instructions.
5.  Do not use this apparatus near water.
6.  Clean only with dry cloth.
7.  Do not block any ventilation openings.
 

Install in accordance with the manufacturer's 
instructions.

8.  Do not install near any heat sources such as radiators, 

heat registers, stoves, or other apparatus (including 
amplifi ers) that produce heat.

9.  Do not defeat the safety purpose of the polarized or 

grounding-type plug. A polarized plug has two blades 
with one wider than the other. A grounding type plug 
has two blades and a third grounding prong. The wide 
blade or the third prong are provided for your safety. If 
the provided plug does not fi t into your outlet, consult 
an electrician for replacement of the obsolete outlet.

10. Protect the power cord from being walked on or 

pinched particularly at plugs, convenience receptacles, 
and the point where they exit from the apparatus.

11.  Only use attachments/accessories specifi ed  by  the 

manufacturer.

12. Use only with the cart, stand, 

tripod, bracket, or table specifi ed by 
the manufacturer, or sold with the 
apparatus.

 

When a cart is used, use caution 
when moving the cart/apparatus 
combination to avoid injury from tip-
over.

13.  Unplug this apparatus during lightning storms or when 

unused for long periods of time.

14. Refer all servicing to qualifi ed service personnel. 

Servicing is required when the apparatus has been 
damaged in any way, such as power-supply cord or 
plug is damaged, liquid has been spilled or objects 
have fallen into the apparatus, the apparatus has 
been exposed to rain or moisture, does not operate 
normally, or has been dropped.

15.  Batteries shall not be exposed to excessive heat such 

as sunshine, fi re or the like.

I

 

This product complies with Part 15 of the FCC Rules. 
Operation is subject to the following two conditions: 
(1) this product may not cause harmful interference, 
and (2) this product must accept any interference 
received, including interference that may cause 
undesired operation.

 

Denon Electronics (USA), LLC

 

(a D & M Holdings Company)

 

100 Corporate Drive 

 

Mahwah, NJ 07430-2041

 

Tel. (800) 497-8921

PRODUCT 
This product, when installed as indicated in the 
instructions contained in this manual, meets FCC 
requirements. Modifi cation not expressly approved 
by DENON may void your authority, granted by the 
FCC, to use the product.

• To comply with FCC RF exposure compliance 

requirement, separation distance of at least 20 cm 
must be maintained between the antenna of this 
product and all persons.

• 

This product and its antenna must not be 
co-located or operating in conjunction with any 
other antenna or transmitter.

4. NOTE
  This product has been tested and found to comply 

with the limits for a Class B digital device, pursuant 
to Part 15

  of the FCC Rules. These limits are 

designed to provide reasonable protection against 
harmful interference in a residential installation.

  This product generates, uses and can radiate radio 

frequency energy and, if not installed and used in 
accordance with the instructions, may cause harmful 
interference to radio communications. However, 
there is no guarantee that interference will not occur 
in a particular installation. If this product does cause 
harmful interference to radio or television reception, 
which can be determined by turning the product 
OFF and ON, the user is encouraged to try to correct 
the interference by one or more of the following 
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment 

and receiver.

• Connect the product into an outlet on a circuit 

different from that to which the receiver is 
connected.

• Consult the local retailer authorized to distribute 

this type of product or an experienced radio/TV 
technician for

 help.

This product complies with RSS-210 of Industry 
Canada. Operation is subject to the following two 
conditions: (1) this product may not cause harmful 
interference, and (2) this product must accept any 
interference received, including interference that 
may cause undesired operation.

  This Class B digital apparatus complies with 

Canadian ICES-003.

 

  Cet appareil est conforme à la norme CNR-210 du 

Canada. L’utilisation de ce dispositif est autorisée 
seulement aux deux conditions suivantes : (1) il ne 
doit pas produire de brouillage, et (2) l’utilisateur du 
dispositif doit être prêt à accepter tout brouillage 
radioélectrique reçu, même si ce brouillage est 
susceptible de compromettre le fonctionnement du 
dispositif.

 

Cet appareil numérique de la classe B est conforme 
à la norme NMB-003 du Canada.

2. CAUTION
  To reduce potential radio interference to other 

users, the antenna type and its gain should be so 
chosen that the equivalent isotropically radiated 
power (e.i.r.p.) is not more than that permitted for 
successful communication.

 

Afi n de réduire le risque d’interférence aux autres 
utilisateurs, il faut choisir le type d’antenne et 
son gain de façon à ce que la puissance isotrope 
rayonnée équivalente (p.i.r.e.) ne soit pas 
supérieure au niveau requis pour l’obtention d’une 
communication satisfaisante.

For Canadian customers:
This Class B digital apparatus complies with Canadian 
ICES-003.
Cet appareil numérique de la classe B est conforme à la 
norme NMB-003 du Canada.

1.RCDN7E3_ENG_008.indd   F3

1.RCDN7E3_ENG_008.indd   F3

2010/09/03   11:11:35

2010/09/03   11:11:35