Panasonic cy-vmx6800u Benutzerhandbuch

29

28

❐ Connect All Leads

Now that you have identified all the wires in the car,
you’re ready to begin connecting them to the con-
troller unit wires. The wiring diagram (

➡

page 29)

shows the proper connections and color coding of
the leads.
We strongly recommend that you test the unit
before making a final installation.
You can set the unit on the floor and make tempo-
rary connections to test the unit. Use electrical tape
to cover all exposed wires.

Important:
≥

Connect the red power lead last, after you
have made and insulated all other connec-
tions.

Ground
Connect the black ground lead of the power connec-
tor to the metal car chassis.

Power 
Connect the red power lead to the correct car radio
wire or to the appropriate fuse port on the fuse
block.
If the LCD monitor functions properly with all these
connections made, disconnect the wires and pro-
ceed to the final installation.

❐ Final Installation

Lead Connections
Connect all wires, making sure that each connection
is insulated and secure. Bundle all loose wires and
fasten them with tape so they won’t fall down later.

Congratulations! After making a few final checks,
you are ready to enjoy your new auto LCD monitor.

❐ Final Checks

1. Make sure that all wires are properly connected

and insulated.

2. Turn on the ignition to check the unit for proper

operation.

If you have difficulties, consult your nearest autho-
rized professional installer for assistance.

Cautions:
≥

This product is designed to operate of a 12 V DC, negative ground battery system.

≥

To prevent damage to the unit, be sure to follow the connection diagram below.

≥

Remove approximately 

1

/

4

q 

(5 mm) of protective covering from the ends of the leads before connecting.

≥

Do not insert the power connector into the unit until the wiring is completed.

≥

Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all
cables and keep cable terminals free from touching any metal parts.

≥

All other installation methods require the use of dedicated metal fittings. Consult with a qualified servic-
ing engineer or your dealer if other methods are required.

❐ Wiring Diagram

ACC

REMOTE-OUT

VTR1-IN

3 A

(Black)

Video (Yellow)

R (Red)

L (White)

(Red)

(Black)

Fuse 3 A

ACC power lead
To ACC power, _12 V DC.

Ground lead
To a clean, bare metallic part 
of the car chassis.

Remote control signal 
receiver lead
To the REMOTE-IN terminal 
of the Panasonic DVD player 
(CX-DV700U).

VTR1 input lead
To the audio/video output 
connector of the other 
device.

2

1

(White)

Room light electrical lead 
Connect to the cord which was 
originally connected.

(Black)

(Red)

Door switch lead
To the switching door trigger 
wire at room light.

Notes:
≥

Be sure to fully plug in the connector.

≥

When game devices are connected, the image may be unstable.

Note:
≥

“REMOTE-OUT” is exclusively
used for VTR1.